Motobecane drive pulley maintenance

Поділитися
Вставка
  • Опубліковано 16 січ 2025

КОМЕНТАРІ • 7

  • @segafreak11
    @segafreak11 Місяць тому

    Oi! Exactly what I was lookin for!
    Got one, with no motor, getting ready to install a generac 196cc on it with a centrifugal clutch setup, but that part gotta go, it’ll be spare part for my other moby 😎

  • @stanssoapbox
    @stanssoapbox 10 років тому +2

    Thanks for the lesson. I just needed to remove the pulley and belt to make it easier for the garage to weld a big crack in the forks on the frame were the stand is bolted to. However I might clean it up and re grease the bearings the same as you did while I am at it.

  • @robertrubin8257
    @robertrubin8257 5 років тому

    Good stuff. I have to replace my chain. It blew out. Wish I could have seen you fumble around with the chain a little more. I would guess one of the reasons my chain jumped and snapped, would be no grease. I have never greased it. Going to attempt this maneuver in the next week or so.

    • @WillieMcphee
      @WillieMcphee  5 років тому

      read up on motorcycle chain tension, too tight is no good and will actually slow you down, too loose will jump all the time, make sure you have some sort of wheel lock on\around the lug nuts, it'll save a lot of headaches

  • @jefersonjosesilva9141
    @jefersonjosesilva9141 3 роки тому

    Aula muito produtiva, obrigado por compartilhar o conhecimento ! Feliz ano novo que Deus abençoe sempre 🙏

  • @jonnybo20
    @jonnybo20 6 років тому

    Very helpful. Just got a cady and it's hard to find anything on them!