How to Replace Rear Wheel Bearing & Hub Assembly 2013-2016 Dodge Dart

Buy Now!
New Wheel Bearing & Hub Assembly from 1AAuto.com 1aau.to/ia/1ASHR00302
This video shows you how to install a new wheel hub and bearing on your 2013-2016 Dodge Dart. Not only can a worn wheel bearing or hub be annoying if it is noisy or vibrating, but it can also lead to accelerated wear in other parts, or unsafe driving conditions. Replacing your worn bearing or hub with a quality TRQ part is a safe, smart, decision.
This repair was done on a 2014 Dodge Dart GT 2.4L Sedan 4-Door FWD Manual and the process should be similar on the following vehicles:
2013 Dodge Dart
2014 Dodge Dart
2015 Dodge Dart
2016 Dodge Dart
Tools you will need:
• 14mm Socket 1aau.to/obVf/1AXAA00015
• 19mm Socket 1aau.to/oax7/1AXAA00043
• 32mm Socket 1aau.to/odI/1AAST00003
• 8mm Hex Socket
• Slide Hammer
• Torque Wrench 1aau.to/oa2Y/1AXAA00044
• Gloves 1aau.to/oaMn/1AXSS00048
• Safety Glasses
• 5mm Hex Socket
• Chisel 1aau.to/omY/1AXAA00055
• Floor Jack 1aau.to/oap8/1AXAA00068
• Hammer
• Jack Stands 1aau.to/oaco/1AXAA00065
• Wheel Chocks
• Wire Brush 1aau.to/owE/1AXAA00079
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money

[@Kalbee]

I like how at the end when he put the wheel on all the new brake parts spontaneously rusted!

[@LukeDuke01.]

I just take the brake reservoir cap off and then push the piston back in, if I don’t have replaced the brake fluid

[@sahilkhan9909]

👍

[@msba1228]

Why did you add an extra step. You could have taken the caliper and the caliper bracket in 1 piece