Pretty nice work, but when you pulled that knife out of the new sheath and there was some torque towards the blade edge, with your fingers wrapped around the outside, I thought you were going to have to go to the ER for emergency tendon surgery. I see that you did cut the inside of the sheath a little bit. Try some sacrificial leather on the edge side, or maybe add some rivets or chicago screws to enhance the safety for your fingers. I watched your video because I want to build a couple Morakniv blanks into knives.
All well and good, but I didn't understand why you didn't make the handle thicker for a better grip on a work knife that takes a lot of pressure with every cut.
Handle's too small and that cut in the handle that you filled with epoxy seems to me to be an obvious point of failure. Should have drilled it and pushed the tang into the handle from the top -- like Mora does.
We old folk use to do this back in the day only we done did whittle down that handle for a down home perfect fit.
We had a six foot oscillating sander at my old shop.
Loved that machine.
Dang! A belt sander may be essential!
Nice job. I may have to do one of these. I’ve always thought a Mora blade with an Opinel handle would make a great tool.
Dope AF results, With These Hands!
Mora kniv is from my country and just love Mora knife. Simple and effective
Pretty nice work, but when you pulled that knife out of the new sheath and there was some torque towards the blade edge, with your fingers wrapped around the outside, I thought you were going to have to go to the ER for emergency tendon surgery. I see that you did cut the inside of the sheath a little bit. Try some sacrificial leather on the edge side, or maybe add some rivets or chicago screws to enhance the safety for your fingers. I watched your video because I want to build a couple Morakniv blanks into knives.
Old folk walked up hill to school both ways without legs and still dropped out with a full scholarship lol
what happened to the bolster ? /
hope the epoxy will keep the blade inside - hidden tang shld be safer
They usually drill the handle but i hope the glue holds up.
I used a two part epoxy to fully secure the wood handle to the tang of the blade. Very durable and hard once fully cured.
Drilling is the only way to go if you want it to last.
@@WithDavidsHands Yeah gotta agree with the above, drilling and pinning the tang is best.
Hmm!??! Not so easy afterall that fun!
Whcih mora blade blank is that? I cant seem to get a sense of scale.
Mora Classic No. 1 (3.9 inch blade)
All well and good, but I didn't understand why you didn't make the handle thicker for a better grip on a work knife that takes a lot of pressure with every cut.
Handle's too small and that cut in the handle that you filled with epoxy seems to me to be an obvious point of failure. Should have drilled it and pushed the tang into the handle from the top -- like Mora does.
Don't believe you're sanding so fine 200 might be to fine I wouldn't want handle sliplly polished
Thumbs down 👎