Making a new coiled heater element for a heat treat oven or a kiln using Kenthal A1 wire

In this video, we'll make some new coils for our heat treatment oven or kiln to replace some defective coil that just died of natural cause... You'll be able to see where we purchased the replacement wire, measured, coiled and tested it, the final results are going to be measured and evaluated after a successful repair.
The heater element is gonna be wound using some Kenthal A-1 from a spool, all the material and tools are available to general public to make your own repairs at reasonable cost.
CAUTION: This video shows how we did the work and you only perform those repairs if you have the necessary knowledge and proper competencies, we're not going to take responsibility for your actions.
Kenthal A-1 was purchased at:
TEMCo Industrial
48621 Warm Springs Blvd
Fremont, CA, USA
Phone:[phone]
Email:[e-mail]
Thanks for viewing and please think about subscribing, liking and commenting...
Philippe's UA-cam Channel:
Phil's Projects
/ phildesjardins1
Pierre Beaudry
Email: [e-mail]