DetonationEMS v1.1 Standalone ECU the on the Sr20det. Almost ready for permanent install!
Вставка
- Опубліковано 15 жов 2024
- DetonationEMS v1.1 is my Arduino powered full standalone engine management system based on Speeduino Firmware!
Wiring testing on my personal car.
The Car: 1990 240sx:
Megan Springs on KYB Struts
Welded Diff
Rear Sub-frame Solid Bushings
Z32 Front Brakes
Sr20det:
Solid Motor mounts
BC2 Cams
Hand ported head
Head studs on stock HG
refreshed stock bottom end with extra ring gap
1000cc injectors (Subaru side feed)
Generic Larger Volume Fuel Rail.
3/8 Fuel Lines on Moded Fuel Sender
AEM FPR (50psi base pressure)
E85 fuel (GM Flex Sensor)
Walbro 255lph feeding an inline Bosch 044.
Custom Modified GTX2871R .86ar turbo with Precision Cold Side Housing.
Cheap front mount
Spec Stage 3 Clutch on Factory Flywheel
Mishimoto Radiator
Homemade 3.25" Downpipe
Homemade 3" Downpipe back exhaust
Cheap Unbranded "stainless" Strait through muffler
DetonationEMS Standalone ECU:
ALL Factory wiring removed in favor of homemade wiring.
Wasted Spark setup using Dodge Coil (early 00's neon)
ECOSpark Coil Driver's
00's Dodge Dakota v6 plug wires (The 4 shortest ones)
NGK Racing Plugs (R5671A-8) 0.26 gap
Factory CAS with DIYAutotune Trigger wheel 12/1
GM 3-bar map sensor
GM IAT Sensor
Factory CLT Sensor
Factory TPS Sensor
Nissan Altima Clutch switch located at the top of the pedal for launch control.
Factory Speed Sensor interfacing with the ECU.
Arduino powered GPS Logging (external)
Arduino Powered EGT Monitor with K-Type Probe from a oven (on cyl 1)
Arduino Powered "BCM" for relay control of body lights and relays.
AEM 4.9 Wideband controller
Cheapest Bluetooth Radio on eBay with 1 working speaker that came with the car.
Looks like a madhouse in there. Love it!
Lol. Thanks. Wiring will be cleaned up soon. Some more wires to run, meth injection control, oil and fuel pressure sensors. She needs a cleaning bad. I've been testing on it more than actually driving it.
@@OpenLogicEFI Yep, gotta get her all sorted out before the final install. Love seeing them in the testing phase though. They are true individual creations at that stage. still there myself
Looking good Aaron. External map sensor ?
Thanks! Ya. The mpx4250ap won't cut it for this build. I run more than 21psi at times. I ordered a few mpx4400's but forgot to put one aside for myself, I accidentally sold them all. Oops. So ya that's a cheap 3bar. Ordered some more 4400's
@@OpenLogicEFI haha, customer come first man. So pumped to begin testing with your board. I checked out your site, where can someone buy them from ?
Amigo las bujias r5671a-8 no t3 dan problema por ser sin reisstencia