echo hc-150 HEDGE TRIMMER carburetor fuel line repair fix

KIT
amzn.to/3fvDE7h
if this video helped you donate a buck or two to my GoFundMe account
www.gofundme.c...
The small engine guys are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com.

[@Rob1fish]

You saved me hours of frustration by showing me how to get that grommet into the tank. Thank you sir!

[@hosseinfaraji5513]

Thank you for showing us the way it is done.

[@smallengineguys]

My pleasure 😊

[@benkanobe7500]

Thank You! You provided everything that mattered with good video and clear audio and links that are current and correct. Thank you so very much!

[@crisso187]

Thanks for the video you made it really easy

[@emmanueldavis2010]

Thanks

[@smallengineguys]

Welcome

[@sensei1781]

The fuel priming bulb on my echo trimmer no longer seems to suck up fuel. I've replaced the 3 hoses, but still seems clogged up. Is there something that can be clogged within the carb that would prevent the bulb from priming? I guess I'll just buy the kit and replace everything, it's cheap enough.

[@smallengineguys]

bad primmer id replace everything including filter

[@sensei1781]

@@smallengineguys Got around to replacing everything with the kit you linked. You were 100% right, my primer bulb had a tear in the bottom which wasnt allowing it to create suction. I went ahead and replaced everything in the kit anyway. Good as new :)

[@Luv2flyMD]

Good video! Do you ever have to put a little oil on the grommet to get the fuel lines in hole?

[@smallengineguys]

usually the kit comes all assembled. i used to though but i found it makes it a bit harder

[@amd65ak47]

I have the same exact pair of hedge clippers I've changed the carburetor I've changed the fuel lines I've changed the grommet on the gas tank for the fuel lines I've changed the gasket on the fuel cap I've cleaned the muffler I put a new spark plug in it New ignition coil has good compression has new air filter all screws are tight It runs for I don't know but 5 to 10 minutes once it gets hot it stalls out and bogs
Any solutions to my problem.

[@smallengineguys]

check and make sure the intake is tight but sounds like the crank seals and bearings are bad

[@thalverlisgriffin]

My prime buld is on the top..

[@smallengineguys]

if it works dont change it