cant help but noticed that ihe two airmixture screws on your carburators, are one :all the way out. and the other : all the way in ,they should both be turned all the way in first than out ca 2.5-3 turns. out on each of them to get the fuel/air mixture right on both carburators , I have just done the same on mine. also double set mikuni bst 33 , mine did go best with 3and 1/4 round on both, then the bike ran great and no issues with lack of power on any trotle range(air mix the two screws are on the underside all the way in front where the inlet manifolds are attached)
Przydało się , dzięki. Fajnie by było gdybyś popełnił filmik z serwisem lag. Pozdrawiam
Jankomoto pewnie się pojawi bo mam uszczelniacze do wymiany. Pozdrawiam i zapraszam również na mojego Facebooka.
Witam . Czy mozesz pokazac gdzie podlaczyc wacumetry. ?
cant help but noticed that ihe two airmixture screws on your carburators, are one :all the way out.
and the other : all the way in
,they should both be turned all the way in first than out ca
2.5-3 turns.
out on each of them to get the fuel/air mixture right on both carburators ,
I have just done the same on mine. also double set mikuni bst 33 , mine did go best with 3and 1/4 round on both,
then the bike ran great and no issues with lack of power on any trotle range(air mix the two screws are on the underside all the way in front where the inlet manifolds are attached)
Can you show which screws are they?
I G L I C O W Y !
Świetnie, dzięki.
Forte abraço
Cris :BRASIL
SÃO PAULO
Valeu amigo
Minha DR 800 esta com esse problema
A boia do carburador esta enroscada e fica c vazamento pelo respiro
Czemu świąteczny obrus babci ukradłeś:)?
To u babci na stole robione :) Pozdrawiam!
@@ttzperformance Pozdrawiam również:)
Mam problem z przepustnicą bo się zacina co można z tym zrobić
Zdiagnozować dlaczego tak się dzieje i usunąć problem.
Czyli gazniki od 800 podejda do 750 bez problemu ?
2:55 to jest oring :)
A czy oring to nie uszczelka? 🤔
español porfavor !!