Thanks for the video, super helpful! May I ask what kind of wire did you use to fire with lighter and take off the insulation to connect the batteries to the long plastic piece?
mukhlis1010 And if you don't have a soldering iron? And you are not really meant to solder, it will damage batteries. That's why they are spot welded sometimes. 😁
Not True At All -- I've been soldering no Head batteries for 50 some years and use the good ones out of a battery-pack for my flashlight & other uses. The only problem there is, is solder doesn't like to stick on battery surfaces so one has to prep the surface properly. And since you don't have the experience in soldering you left the soldering iron too long on the battery. Learn how to solder and then soldering works just fine. Do it right and save money - rechargeables aren't cheap.
If you connect batteries in a series and parallel, they all must have the same capacity. And they must be paired. So you can connect 3 batteries in series for 3.6V and then connect that in parallel with additional sets of 3 to keep them at 3.6V but increase capacity.
so when I want to take electricity from them, the idea is to take one from minus and one from plus no matter from which battery, it is like I want to connect D2 Duracell batteries (Recharge ultra long lasting power) so yes, I want to connect 22 pieces together, can help understanding it a bit more ?
md umar You are asking if you can charge it with a usb 5v phone charger. Wich I'd answer, depends. It shouldn't be straight 5v output but it has to be converted If I remember right.
Looking to make this to test an ebike throttle but also need either an included diagram or slow down a second to see how batteries hooked together as idk elect 4. shhhhhhhhht. Anything once learned is eaaaaaasy.
With a solar panel, wind turbine, geomagnetic field, geothermal fluxuations, bigger batteries, cut up a wall battery charger cable and plug it into your batteries.. lol
i tried to use some copper wires i pulled out of my phone AC charger, but when I went to connect the other side (like how you connected both sides of the +-,+- ) but it started getting hot, and it burnt me a little. Am I doing something wrong?
nvm i figured it out. i was connecting the 2 batteries parallel on both ends instead of parallel on one end and a separate wire for the (+) and (-) on the other
i have a rc speedboat that runes on the Ni 1700mah,7.2 v but it was destroyed and i cant find it, with very limited options ,the device already requires it, how hard to obtain n the same mAh and voltage from regular disposal or rechargeable AA batteries? thnx
![[2020] How to Solder 18650, AA, 9v, or ANY Other Battery (To Make Battery Packs) | Safe & Quick](/img/n.gif)
1:49 moment of innovation when this youtuber brought the lighter instead of any wire cutter👍👍👍👍👍👍
Finally a tech video without garbage techno music, thank you so much
I know I am kinda off topic but does anyone know a good place to stream newly released series online ?
@Rex Jace try Flixzone. Just google for it :)
@Yusuf Duncan definitely, I have been using FlixZone for years myself :D
@Yusuf Duncan thanks, I signed up and it seems to work :) Appreciate it !
@Rex Jace glad I could help :)
Legit tried this out right now and it works amazingly! Thanks a ton.
This helped me tons with a school project for the kiddo. Thanks!
Same here thanks man.,👍👌
Wow mindfull and with out soldering
i will use for my electric fan
thanks to you
sir
Thanks for the vid. If it's too fast, you can change the playback speed ;)
Awesome bro thanks for this video
Can we also use copper wire.... Please sir reply
Thanks for the video, super helpful! May I ask what kind of wire did you use to fire with lighter and take off the insulation to connect the batteries to the long plastic piece?
looked like copper wire to me
Chup kar nai kuti
Very well 👏👌
Nice video
My son has a toy with 4 AA batteries which lamp holder do i need to connect it too?
This is so excellent. Thank you.
Very nice
Nice
One in the eye for maplins.....
You now look down to Flint Lockwood.
nice bro ma yhi to cahatha tha
👍
Tk you soòoooooooooooooper it is helpful
tnx it works perfict
Super
Thnx dear
Esme wire Kon sa use kiya hai apne .
MacGyver level 9999+
another great channel to subscribe to,thank you.
Thanks man, helped me a lot!
it looks more difficul than soldering ..?
mukhlis1010 And if you don't have a soldering iron? And you are not really meant to solder, it will damage batteries. That's why they are spot welded sometimes. 😁
ya you are right bro
mukhlis1010 Xcvj
Not True At All -- I've been soldering no Head batteries for 50 some years and use the good ones out of a battery-pack for my flashlight & other uses. The only problem there is, is solder doesn't like to stick on battery surfaces so one has to prep the surface properly. And since you don't have the experience in soldering you left the soldering iron too long on the battery. Learn how to solder and then soldering works just fine. Do it right and save money - rechargeables aren't cheap.
@@demaXxXx Heey, looks like you are more talented in this than me! What is that white thing which he connets the batteries?
thx i solved my battery problem :)
Rubber bands the lazy man's solder
XD
Yeah but can you fix your autofocus? Good idea but the amount of work, just be easier to solder everything. Good idea though
What is those browne things on battery the one that he put, is it just a metal?
Can I use fuse wire?
ima attach alot of batteries and put them in my rc car
Did it work?
did it work?
Does this same circuitry also applies to 18650 cells
it should
it is not easy I'M FROM 🇮🇳 INDIA
sir jis wire se app ne hook banaya jo do do me magaya hai uska name
Saaad Khan Copper wire from a LAN cable I guess.
kisi 0r cheez se nh hosakta
can I can conect 3 batteries 3.7v 1000 mh in cerie and 2 3.7v 1000mh in parallel to make a pack and how to charge it and balance? thanks
If you connect batteries in a series and parallel, they all must have the same capacity. And they must be paired.
So you can connect 3 batteries in series for 3.6V and then connect that in parallel with additional sets of 3 to keep them at 3.6V but increase capacity.
How much will be the volt of 4 batteries if they are 1.5V each
6 Volts
Series 6v or parallel 1.5v
is that copper wire??
was it copper which you had used in 0:38
I'd bet your life on it being wire made of copper
Can v use it for 3v 1ft led strip
does this work with more than 4 batteries?
This would work with 1000 batteries if you want.
it would but you'd need bigger lolly sticks
@@Pasturesv Yes and destroy the device you connect to it considering each added battery is +1.2V
On 1000 of em that would be 1200 V
in series right?
Use an led light instead of a motor it would be easier to see
yah, with the music there's no telling what is going on with the motor.
Wanna fry it maybe?
so when I want to take electricity from them, the idea is to take one from minus and one from plus no matter from which battery, it is like I want to connect D2 Duracell batteries (Recharge ultra long lasting power) so yes, I want to connect 22 pieces together, can help understanding it a bit more ?
NO DON'T!!!
This is connecting batteries in a series! If you put 22 of them together you will get 26,4V on exit! (Assuming each battery is 1.2V)
Bro in the time of making does it produce heat please help me 😢
Bro you are doing wrong connection 😂😂
can you make a video of pairing up 6 batteries
Jaynil Patel yes
Amateur, do it with 6000 batteries
@@Rusiputki But this Time not in a Row xD
it was good but little fast
Easier to buy a 3 or 4 battery holder
Oh ok thanks :)
it is the coper wire
You make 12v battry please make
Would these be in series or parallel?
Series.
it is more easier to take the battery one upon one
COOL EASY NO NEED OF SOLDER WIRE😂😂😂😂😂😎😎😎👏👏👏👏👏👏👏👏✌✌✌👍👍👍👍👍
How to much DC VOLTAGE we obtain from this method
Yes true video
wonderful
Ese charge kaise kare
Can we connect more batteries to it?
Dakshesh Pandey! Yes
is it rechargeable with a mobile charger withtout the usb port ??
md umar how
With a mobile charger without usb port , I am confused what are you trying to say
md umar You are asking if you can charge it with a usb 5v phone charger.
Wich I'd answer, depends. It shouldn't be straight 5v output but it has to be converted If I remember right.
NAIN NAIN NAIN NAIN
How to make a 5v battery.
Clever
Can this go up to 12 v
Hello bro positive negative ulta pulta Lagaya problem Nahi Hoga Kya please bolo na bro main v Banaunga
3 cell ke battery bale video
Looking to make this to test an ebike throttle but also need either an included diagram or slow down a second to see how batteries hooked together as idk elect 4. shhhhhhhhht. Anything once learned is eaaaaaasy.
hard
एक सेल कीतने वोल्ट का आता है
How do recharge the batteries
With a solar panel, wind turbine, geomagnetic field, geothermal fluxuations, bigger batteries, cut up a wall battery charger cable and plug it into your batteries.. lol
I will try
it's best to do it using electricity
Hello
Neetu Kanwar hgghhffffdfhhhvcffvvcvjhcfgh
Hello! dont you know what does he uses to connect the batteries? Is it just a piece of plastic?
NIce.
Pity the video is so jerky.......
Thanks for sharing.
i tried to use some copper wires i pulled out of my phone AC charger, but when I went to connect the other side (like how you connected both sides of the +-,+- ) but it started getting hot, and it burnt me a little. Am I doing something wrong?
Maybe the type of batteries that you are using is the problem
nvm i figured it out. i was connecting the 2 batteries parallel on both ends instead of parallel on one end and a separate wire for the (+) and (-) on the other
im comfused
Bhai use charge kaise Kare
Is it chargeble
If you use rechargeable batteries, it should be
Can i use paperclips instead?
Caroline Suzon try to use it. but, i'm not sure it work
LXG Design of course it will work, unless their coated in something
another cool idea...
TFS
No, you are not allowed.
@@lxgdesign Hello! Can you please tell me what material do you use for connecting the batteries together?
جميل جدآ ✨🖤
Tune Pehle char batteries le phir ek dum teen Ho gayi
Charge bale better charger
How to charge
Good luc
too fastt video man
Can it work on two batteries?
Yes as many as you want within reason
Can I use these four batteries in my RC car instead of lithium batteries.Is my RC car work ?
but howe we charj this
it,s not only the volt ,but the ah that coins
Do ít slowly!
I need a little help. may I use 8 batteries instead of 4 to make it more powerful
Yes but watch out
+Poneomenus Trismegistus thanks for reolying
wanna make a pack with 17000mAh and 7.2 V ?any ideas?
Moh Redwan Buy it :)
u gonna be kidding me !!??
because it's very hard to make. And it can damage your devices
i have a rc speedboat that runes on the Ni 1700mah,7.2 v but it was destroyed and i cant find it, with very limited options ,the device already requires it,
how hard to obtain n the same mAh and voltage from regular disposal or rechargeable AA batteries?
thnx
Moh Redwan i think it's ok with battery 7.4V like this www.batterysupports.com/72v-74v-10-18650-17ah-2s5p-lithium-ion-liion-battery-pack-p-90.html
Instructions unclear accidentally made a bomb
इसे चार्ज कैसे करें
I can't follow
so faster
impossible to see what you are doing, hold still and slow down or have subtitles
Hai
चार्ज कैसे होगा
Do that work?
Can we charge again in charger,does it charge??
the video is running so fastly.
Your brain is just too slow.
If u want to know that do this works or not then the answer is: Yes