Short Version Video 2nd Gen High Clearance Rear Bumper and Tire Carrier

Here's the short version of the build video on a high clearance rear bumper and swingout tire carrier for a 1995 2nd Gen 4Runner.
The full video is at • Rear Steel High Cleara...
My Amazon storefront link where you can find some of the items I use in these videos is at www.amazon.com...
Ill get a small payment at no cost to you if you purchase any of those items through that link, which I would totally appreciate.
Thanks for checking out the video and if you have any questions please reach out. You can find more info on my builds at bentleycustomoffroad.com
Have a great day.

[@ryanhensley146]

I really enjoy your videos. Do think a 125 amp flux core welder could do this job?

[@OffroadGrind]

Hi Ryan. Thanks for checking out the video and I’m glad you liked the info. Yeah man, that would be fine. Don’t rush through the line when you’re welding 3/16. Crank the amps up to as high as you can get them, pause a bit at the start of the weld to heat things up, then keep that puddle going as you weld along the line to get that steel burned in nicely. Flux core is a bit messier but nothing that a sander can’t clear up. Actually flux core often puts a better melt in there than MIG. You got this Mr.

[@ryanhensley146]

Man I am so glad you said that. Do you think I should use .030 or .035 flux core wire?@@OffroadGrind

[@OffroadGrind]

@@ryanhensley1460.030 would be fine. Just go slower if welding anything over 1/8” thick to make sure the weld is getting into the steel (getting good penetration).

[@ryanhensley146]

Thank you so much. I really appreciate your help. I will keep watching. @@OffroadGrind