3D Printed Hydroplane Boat (Part 2)
Вставка
- Опубліковано 15 вер 2024
- 3D Printed Hydroplane Boat
Filament PLA
Brand: Esun
Specifications:
Hull Length: 30.5 inches (77.50 cm)
Beam: 16 inches (410 cm)
Weight: 42 oz (1.5kg)
Lipo Betterry 4S -6S 2200-3500mah
Brushless Motor 3670 2650kv W/Cooling Jacket
Speed Control Favourite 100A waterproof (Forward/Reverse)
Servo Standard Water Proof 1pcs
Flexible Shaft Prop Nut Drive Dog 4mm
Propeller 42mm/4mm
Shaft adapter, Coupler 5x4mm
Linkage Stopper Servo Connectors
Silicone water Pipe 4 mm
Water Outlet 6mm
Waterproof Push Rod Seal
Waterproof electronics
Radio Futaba 3PV 2.4GHz (3-channel)
RX Corona (3-channel)
Thank you for watching
Please subscribe to our youtube channel / @mr.rc-creator
Cr.Alberto Perez Barroso
STL FILE. www.thingivers...
awesome!
Thanks.😁
Love this!! Im printing your catamaran right now..... as soon as these files are available Im doing this as well!
Great.! 👍🙂
Bellissimo ,Complimenti 👏
La ringrazio molto😁
Grazie.
Buen trabajo!!! Se desliza muy bien y se ve que es muy estable y el refuerzo en carbono le da esa rigidez que necesita el casco.. 👌
muchas gracias 😁
super bonjour de la France
merci beaucoup😇
Muito linda!
obrigado😁
?what battery do you think it runs best on (4s,6s)? thanks!
I think 4 cells or 6 cells work equally well, but the performance is quite different for 6 cells.
question, i built this boat with the same motor you did but used a 90A water cooled esc. when i put it in water ans give it throttle the motor cuts out. Any thoughts? Thanks again!
Is the battery you are using still good?
Speed Control: What is the cutoff set at?
Does the motor shaft eventually wear out the opening in the hull that it goes through? Also, how do you keep it water tight where the shaft exits the hull? Thanks
Sorry for the late reply water can't get through the shaft because I use grease and oil to lubricate the shaft every time I put it in the water.
There’s no wear because the shaft goes through a stuffing tube that goes through the boat !
@@Budgetrcbuilds It is a flexible boat shaft with little wear and tear and can easily be replaced.
@@Mr.RC-Creator I’m printing one now ! And trying to stuff 6s in it 😂🤦🏻♂️
@@Budgetrcbuilds It's going to be fun!!😂
hello I made the boat in 3d printing did I install a thermal engine in it there is no risk that the ceiling please thank you cordially I am waiting for your return
I think you can do it but there should be a vent for venting the engine, I think it's better.
thank you for your advice is the pla it will melt with the heat of the thermal engine in a small question the carbon canvas you order it or and for the application I see you put resin is it possible to have the link for all that please thank you
@@dimitrybattesti7930 I think you should use PETG 3D, it will be more heat resistant and you can do the same for the boat with carbon cloth as well.🙂
hello I ask you for the plans of the rc hydroplane boat in this video Thank
@@dimitrybattesti7930 You mean STL files?
the stl file ?
www.thingiverse.com/thing:4834947 🙂