Відео

very very good

thank u for the video 2nd saab.

Hopefully you can share video for overhauling of exhaust valve.tnx sir.

Thx from morocco

Thanks for your valuable information and clear explanations. I hope you continue posting more about the WIN GD engine.

very helpful

Thank you sir, If you dont mind, could you upload about me-ga engine ??

It's Very useful, Thanks for uploading this video Brother

Sir Does the venting always operate even if the engine is not using SCR?

Very Good Explanation, Thank You Sir.

very helpful video! many thanks , safe seas!

Thank you for the video

Thank you..

Thanks a lot for very valuable video and your channel.❤❤

Thanks a lot for your valuable video.❤❤

Very helpful explanation sir!!Thankyou

Excellent presentation.Thank you

very helpful.Thank you.

Thanks

Thanks

But where is the draw card

Thank you soo much sir 🙏🙏🙏

Thank you sir. Very detailed video and you explained each step in so detail that I have no further doubt regarding bottom end bearing renewal. Thank you very much sir.

pls throw some light on LDU's Exhaust Ventilation system

Today my doubt cleared regarding urea vs ammonia in SCR

Very informative video sir , please keep doing ❤

Thank u so much for video

اهلا اخي انا من الجزائر انا في ورطة هل يمكن التواصل معك

Many thanks for spreading such wonderful videos. Great effort . I m tsi with fleet. Please contact

Thanks !

Thank you so much for the video

Good job ! Thanks !

Thanks a lot !

is 150 bar nitrogen bottle 40 ltr unitor enough for charging accuulators??

Excellent,Thank you.

❤ thank you for sharing the knowledge

Very informative video

Very nyc content

Hi sir. Can you make video please on VIT and Super VIT from basic

very helpfull video ...keep it up broo;)

U told the story but not tell why 2 flame dye used

Never never dismantle the tangential slot cone and the orifice, it will disturb the factory setting, and the incorrect torque of the nut will disturb the atomization pattern, better to only flush the strainer of the atomizer with gasoline or lighter solvent, renew the O-ring every routine, also renew the nozzle every 6 months.

Which manual is this?

Great video, thanku so much.

great video sir, can u plz add the part where they check the bearing clearance.

Excellebt video ..thank you for your efforts!!

Good to see you man❤️❤️ I was watching the video and thinking this voice sounds familiar😃

when zero calibration (0.2bar) time must be waiting 2min, that was need time to stabilize

Good video

excellent