![E-Josh Rc](/img/default-banner.jpg)
- 73
- 195 171
E-Josh Rc
Приєднався 28 гру 2019
Nitro and Electric RC Car Videos
Team Losi LST Super Truck Start Up & Idle! Dynamite Mach .26 Reawakens!
This is an old school Losi LST Super Truck with upgraded shocks and springs.
Переглядів: 196
Відео
Traxxas T-MAXX 3.3 Cold Start After Front & Rear Bearing Replacement! No More Grinding Noise!
Переглядів 1628 місяців тому
This is an old T-MAXX 3.3 (4909) that was converted to a forward only and pull start. The replacement engine bearings that were used were Fast Eddy Bearings for the 3.3 engine. Note: A bad rear bearing will sound like a crunchy/grinding noise. To remove front and rear bearings you would need to heat the block up with a heat gun. After heating up the block enough, simply tap the back of engine o...
Hpi Savage 25 Sunday Morning Two-Speed Testing! Running Rich Below Half A Tank!
Переглядів 768 місяців тому
This is an old Hpi Savage 25 that was restored as close as possible to stock. The engine was freed up and transmission inspected. It was tuned at half a tank to stop the half tank lean issue. Nitro Star S-25 Factory Needle Settings HSN: 4 1/2 turns from closed LSN: 3 turns from closed
Hpi Savage 25 Cold Start After Restoration! Nitro Star S-25 Lives Again!
Переглядів 6829 місяців тому
This is an all original Hpi Savage 25 that was restored back to a factory look. It still has the Nitro Star S-25 and old electronics. Note: Hpi Savage 21/25 have reverse threaded axles/locknuts on the left hand side of the truck. They are silver colored. The right hand side are normal and are colored black.
Traxxas Nitro Slash 3.3 Burning Tires & Tearing Up Dirt!
Переглядів 1879 місяців тому
This is a Traxxas Nitro Slash 3.3 with a pull start system installed. The shocks are using linear rate springs instead of progressive rate springs.
Traxxas Monster Slash VXL Skatepark Run! Big Air!
Переглядів 809 місяців тому
This is a Traxxas Slash 2wd that was converted into a monster Slash with a VXL3-S system. It started out as a brushed rtr.
HPI SAVAGE X 4.6 Cold Start! K4.6 Brought Back To Life!
Переглядів 3109 місяців тому
This is an older HPI Savage X with the K4.6 Nitro Star engine and purple anodized aluminum parts. It was sitting in storage for a long time from the previous owner. The K4.6 has more top end over the F4.6, but the F4.6 has more low end power. Parts Added: HPI Black 17mm hex conversion, HPI Big Bore Shocks, Proline Trencher tires/Proline Raid Wheels, and Redcat 2.4 GHz Radio/Reciever.
Traxxas BANDIT Night Time Drive! New Model With LEDs
Переглядів 3029 місяців тому
This is the new Traxxas Bandit XL-5 model that has the new flat chassis that can hold longer batteries, new wheels/body color, and has the new front/rear LED light kit.
Short Wheelbase REVO with a Traxxas 3.3 Engine!
Переглядів 15110 місяців тому
This REVO 2.5R has been 3.3 swapped. It also has the 6061-T6 Aluminum REVO 3.3 chassis brace installed, part #5361.
Hpi Savage 21 Returns To The Track! Initial Shakedown Run
Переглядів 4 тис.Рік тому
This is a restored Hpi Savage 21 that is using a Dynamite .21 engine and an OS #8 glow plug. The truck is using 20% nitro with a 9% oil content. The shocks are using 30 wt oil and have 4 lbs aftermarket blue springs.
Hpi Savage 21 Shifting Into 2nd Gear! Shiftpoint Set Between 3 - 4 Turns Out
Переглядів 2,7 тис.Рік тому
This is an Hpi Savage 21 that was restored back to running rich and loud! The shift point was set somewhere between 3.5 - 4 turns out on the 2nd gear clutch. I first turned it out to 4 turns and it shifted way to early, so I started to make small adjustments by turning the set screw in until the truck started to shift a little later. “Note” The second gear clutch adjustment screw is the second ...
Nitro 4-Tec Slow Motion Donuts & Power Slide!
Переглядів 390Рік тому
Nitro 4-Tec burning tires in slow motion!
HPI Savage 21 Starts Up On Second Pull With New Dynamite .21 Engine!
Переглядів 1,2 тис.Рік тому
This is an original HPI Savage 21 that has a fresh Dynamite .21 Nitro Engine. To fit this engine I had to shave both inner sides of the motor mount a little until the engine did not need to be forced onto the mount. This specific engine takes a standard glow plug. I’m using an OS 8 medium plug and 20% nitro with 9% oil. The Dynamite Li-Po glow plug igniter was used in the video. (Starting Tips)...
REVO 2.5R Sliding Towards Camera! Slow-Motion/Real-Time
Переглядів 1,9 тис.Рік тому
REVO 2.5R Sliding Towards Camera! Slow-Motion/Real-Time
REVO 3.3 Backflip Off Of A Storage Container! Real-Time/Slow-Motion
Переглядів 1,7 тис.Рік тому
REVO 3.3 Backflip Off Of A Storage Container! Real-Time/Slow-Motion
Traxxas REVO 2.5R 10 Gallons Of Fuel Celebration Run! Original Engine Won’t Quit!
Переглядів 972Рік тому
Traxxas REVO 2.5R 10 Gallons Of Fuel Celebration Run! Original Engine Won’t Quit!
Duratrax Maximum MT Pro Startup & Idle! Torq .16 Back From The Dead!
Переглядів 3,3 тис.2 роки тому
Duratrax Maximum MT Pro Startup & Idle! Torq .16 Back From The Dead!
Old Traxxas Pro .15 Quick Startup & Revs On The Nitro Rustler! Tuning Settings In Description
Переглядів 2,6 тис.2 роки тому
Old Traxxas Pro .15 Quick Startup & Revs On The Nitro Rustler! Tuning Settings In Description
Redcat Thunder Drift Servo Saver Delete & 25Kg Metal Gear Servo Upgrade! Drifting Around Cars!
Переглядів 7442 роки тому
Redcat Thunder Drift Servo Saver Delete & 25Kg Metal Gear Servo Upgrade! Drifting Around Cars!
Redcat Racing Thunder Drift First Run With A Custom Nissan Skyline Body!
Переглядів 8492 роки тому
Redcat Racing Thunder Drift First Run With A Custom Nissan Skyline Body!
Team Associated TC4 Drift Tire Testing! More Info In Video Description
Переглядів 1,4 тис.2 роки тому
Team Associated TC4 Drift Tire Testing! More Info In Video Description
Traxxas REVO (5310) Working Opti Drive Demonstration/Shift Linkage Positions
Переглядів 13 тис.2 роки тому
Traxxas REVO (5310) Working Opti Drive Demonstration/Shift Linkage Positions
Nitro 4-Tec Burning Rubber & Shifting Into 2nd Gear!
Переглядів 6932 роки тому
Nitro 4-Tec Burning Rubber & Shifting Into 2nd Gear!
Nitro Stampede Two-Wheel Drive Action With The TRX 2.5 Engine!
Переглядів 6162 роки тому
Nitro Stampede Two-Wheel Drive Action With The TRX 2.5 Engine!
Custom Dodge Ram Monster Slash VXL 2wd Test Drive Around The Track!
Переглядів 1,8 тис.2 роки тому
Custom Dodge Ram Monster Slash VXL 2wd Test Drive Around The Track!
LaTrax Teton Metal Ford Bronco Body Installation & Test Drive!
Переглядів 3132 роки тому
LaTrax Teton Metal Ford Bronco Body Installation & Test Drive!
Excellent 👍
I could never keep a clutch in my tmaxx, I was lucky to get a half gallon out of it. I do miss nitro but electric just out preforms these days.
🆒 video & ℹ️ have 1️⃣0️⃣ HPI savage 2️⃣5️⃣ 🤑👍🏼🛻🏁
🆒 video & ℹ️ have 4️⃣ HPI savage 2️⃣1️⃣ 🤑👍🏼🛻🏁
Mine is only running backwards I have swapped the diffs over but still not going forward any ideas
❤😂🎉😢😮😅😊. ไฟแอดพ์.
Is that a tmaxx classic chassis?
This is the original short wheelbase TMaxx 3.3 chassis with the gray transmission. with reverse (I converted it to forward only with part 5195). The part number for the 4mm chassis with no exhaust cutout is 5122R.
@@e-joshrc5877 is the grey tranny a direct fit or is there tinkering involved
Love those ..i love the savage more but great trucks
But do u run it
Love it, Paul Walker would be proud. Got myself a blue one to go on my Redcat Lightning chassis. Thanks for posting! New subscriber.
If just engine 21! 3,5 cc run prity Well fore' thats monster weght.
What paint did you use for the body
Usually you’re supposed to use polycarbonate paint for lexan. I recommend Duratrax or Tamiya polycarbonate spray paints. The body in this video however has black plastidip as an experiment.
I have one but can’t get it running:/
Hpi Savage 👍
Revo 3.3 have reverse speed?😮😮😮😮
link to wheels ?
I tried to get mines to Willie, but I just can’t. I don’t know if it’s because of my altitude in Colorado or I just suck at tuning.
Awesome, I'm in the process of restoring a Savage 25, love them! 😊
just so you know those diffs are not revo spec and do not like bigger wheels
I’ve had no problems at all, just geared down and it hauls! These tires are not belted and are lightweight.
I have a similar situation with mine, as it’s been sitting for 10 years, the receiver seems to be acting weird
Nice
How is there 30 views and 59k likes?? Which one is telling lies
UA-cam there app is really really going down the drain at this point it makes me want to rip out my hair every time I use the service anymore
i have a friend who has one of these, almost exactly like this one. i have not been able to get it started since the summer. i wonder if the carb settings arent rich enough because it gotten cold out compared to summer. i dont think the fact the engine has super low compression helps though.
If the LST you got has the Mach .26 you could try the stock settings of 3 1/2 turns out from closed on the HSN and 2 turns out on the LSN. Usually if you can’t get an idle the low speed needle needs to be tuned. I got good results with a slight lean LSN and a rich HSN.
@@e-joshrc5877 i'll have to give that a try at some point
Paper towels under the pipe tip. 😋
I have the same light kit on my bandit they look so realistic expecially when I do my nite speed runs it gets compliments in my apartment complex 🤘
Nice sounds good
Nice I love nitro
Nice
How much did you pay for it?
some good shifting. need to get my friends LST going...
Looks really nice! I’m restoring my used tmaxx classic at the moment can’t wait till it’s finished
sounds real nice
The Beast is Back! oh yeah
ya thats good old nitro power
lol cool
nice love my nitro rc, how do you clean them after a run like that?
Usually I use compressed air, toothbrush/paint brush, and a rag. I also use simple green, soapy water, and WD-40 when needed.
Brap
Love the older classic/vintage nitros
😂😁
Nice
How has this engine been treating you so far?
@mannyrcon It’s been very reliable and easy to start when warmed up with a hairdryer first.
Great video! I have a Revo 2.5 and I need another body. Do you know where I could find one?
Jconcepts bodies can work on the REVO. As long as it’s a 12-13” (12.5) wheelbase and 7.5” width. I’m curcurrently running the 2005 f-250 body on my short wheelbase REVO! There will need to be trimming around the bumpers though.
Thanks
Thank you for the HDR content it is much appreciated!
How fast is it
Around the 40-55 mph range, similar to a Jato.
nice build but this aint a real 4909 model cause chsssis braces aare suppose to be grey and the chassis doesnt seem to be 4mm thick current tmaxx chassis are 3.2 mm thick the short chassis was discontinued in the early 2000s year not bashing your truck but 4909 are extremely rare to find now days
It’s a real one from 2007, the camera angles made the chassis braces look black. The reverse was removed and the plastic pipe was changed to the aluminum one.
Mine has no low speed adjustment on carb. There is simply no slot to turn
You probably got the regular .15 or the .12 carb on the engine.
Slow shit ox
Nice, that track/park looks like fun! I’m fixing and cleaning up my old and dirty Savage 25, taking it out tomorrow.
i always wanted one when i was a kid and i still do now
Would you want to sell the body or trade for a new 1 of your choice? I'm trying to find a decent t stock body and am not having much luck. Check out the proform type s.
I have one