Відео

Fun to drive, epic POS to actually own.

to remove the Audi A4 B6 1.8 t engine, did you support the gearbox or not, I'm waiting for an answer

What front break pads did you use mine have to much meat on them

Just bought a 04 . I want to do this . Hope it works 💪

Well you Tried, Hopefully the next vehicle will be better.

Da li ide bolje kad se ocisti eger

came here for trans fluid video but is that a chevy nova?

Even though the old carb looked clean I guarantee the pilot jet was clogged up because u didn’t take the jets out and inspect. U should be able to see light when u look through them. Also carb clean every possible hole and then blow out with air. That cost you a big headache and a month delay. The leaking oil sensor is a common issue. I used rtv casket maker to seal mine up and hasn’t leaked since.

Nice job , now see mine isn't stock so I'm premixing mine , I know where fuel line is but not where the secondary line goes to I know it's to pump the fuel but mines not pumping ..

So when removing the HB bolt, you’re stealing it down so it doesn’t move???

I need to do this to get to my front crankshaft seal that’s leaking in my 04

somethings been leaking out from my exhaust and today it stopped a little bit concerned

Same thing happen to my 2007 Ranger, I thought i had the wrong part... my belt went on the same rubber part and was still running... thanks for this video

Good Job 👍 I think the Float is bad or needs adjustment on the old carburetor I wouldn't throw it away always good to have parts, I like that champion plug gapper where did you get it? Looks like your girlfriend was having a good time. And the Denso Hat is Bitchin I gotta get one.

Now do it at their max voltage rating 😊 (according to one on digikey, 32V)

I have a 2-door Datsun B-210 Sedan, and I want to restore it. I have a lot of work ahead, but your videos have motivated me even more to put in the effort. I hope you upload another video in this series soon!

Most useless video ever. No results.

Definitely Different Never Saw a Video about Blowing up Fuses 😅 and if you ever get an old vehicle with glass fuses don't listen to someone if they say oh wrap some aluminum foil around it to complete the circuit you will be fine 😅 only do it if you can determine it didn't blow because of a short, cause if not you take the risk of burning it to the ground.

Approximately how much transmission oil should be added to A4 2l alt engine 2004 model

My coils of my 1.8 T have just reach 27 years and not change

Thank you for making this video this is exactly what happened to my 2005 Ford Mustang the belt came off and was riding on the edge of the harmonic balancer just like yours was in the video I didn't know for sure whether or not it was the balancer but after I seen your video I figured out the same thing happened to you happened to me again thank you for making this video.

THANKS A LOT!!! I've been searching for a video that show me how to remove this type of radio but nothing...until you appeard. Again thanks

why didn’t you just make a vent mount that looks pretty bad tbh

almost makes me wish i still had my 76 B210 coupe . . . almost

strange - my 76 210 coupe had rusted front floors but a solid trunk my new trunk floor was just 3/8 plywood

Thank you for this. Excellent information! Saved my day.

Where did you run your power wires at? I couldn't see clearly how you ran the wires only asking because I have another A4 I'm trying to run the same gauge you have on my Where did you run your power wires at? couldn't see clearly how you run the wires only asking because I have another A4 I'm trying to run the same gauge you have on my car but defiantly not in the same location.

how about the center console electical problems

It is just under filled you have to put 8 qts in after filter change on a 4x4 Explorer and let it run out as it warms up when warm and it starts coming out slow then put the screw back in make sure it doesn't leak then you are good

Bummer fella. The fluid should be a red color not MUD color. I would bet the system is not getting cooled properly. ALSO, the transmission filter is probably plugged so good you replaced with new one. I can tell you your transmission is TOAST FOR SURE.. You should change the fluid every 30000 miles and you would never need a new transmission fella, THAT IS A FACT. GOOD LUCK STUIE !!

Nah…. I’ll stick with driving Toyota and Lexus cars. This German garbage will bankrupt you. These cars are endless money pits

Que paragolpes más horribles 😢 ese aspecto U spec lo detesto

Mano muito bom seus vídeos..tenho um 1.8 turbo automático CVT 2004 aq no Brasil..vou olhar as coisas q vc disse em outro vídeo q é bom trocar e tal..o meu eu peguei ele com 141 mil km..já rodei 6300..estou trocando um monte de coisas..

Isn't there suppose 2b a cork gasket on the flange?

Thumbs up for dropping your tools in the old oil!

I’ve got a 03 a4 1.8t and I haven’t been able to jack it up yet, but I’ve got an oil leak that’s coming from somewhere. Far as I can tell it’s leaking down to the front passenger control arm. If any guess as to what it is I’d appreciate it

You are so patient. I find myself watching for over an hour. Great video. I have a datsun 210. Keep it up 👍

Having this issue with my 05 ranger. everyone legt thought the wrong part was installed because the way it looked in the photos. this video just saved me soooooooo much headache. TY

Hi - I'm currently doing this on my 2005 Mercury Mountaineer but I'm having trouble pulling mine out. You used the same screw that you'll use to install the new balancer?

Ok, 2002 1.8L Quattro here. I start it, put it neutral, pull the 17mm check/fill plug and atleast a quart comes flowing out at a high volume before i can get the plug fully threaded back in. Its atleast a quart and didnt seem to want to slow any. WTF???????

Lol i totally felt that moment when the socket fell into the pan 😂 also thanks for the video Also why did they hide the dipstick?? Whack

I'm confused. I read this about EGR and Combi valves. "The EGR has a line in from the charcoal canister, and out to the throttle body. The Kombi valve has a line in from the secondary air pump, and is connected to the exhaust manifold, and also has a vacuum line attached to the side controlling the actuation from the solenoid that controls it ". Google. Are they the same ?...Many videos show replacement of this valve as combi ?....thanks ! lmk please

Nothing here that a competent garage that can spell Audi will not be able to fix.

more involved than I thought

Got any idea how to solve P0171 on the 1.8t? I already replaced the crankcase Ventilation system that was obv. damaged but the fault code still comes back. *I also have freeze Frame readings if that helps

I think you should add a 10" subwoofer and 100 watt amp. LOL

Short, simple and to the point. Awesome sauce. Thanks dude

Nice. Thanks!

Thanks for the video man. I’ve done this job before but needed to do it again, and your video got straight to the point and was super easy (also bought a new VCV because you pointed it out, and that is likely the issue on mine, but since I have a new pressure regulator anyway might as well install!)

Great video! Did you end up replacing the turbo?