Відео

I just did mine ,from35” to 33” , with a reverse taper golf pride grip , feels way better now , hopefully some birdies and pars lol

Easy way to tell is that Taylormade woods have a serial number on the back of the hosel.

should of finished the whole regripping, but you got to the hard part and stopped. 🤬

Thank you so much for the advice Removed one of my favourite grips and refitted the same grip but with 4 extra layers of tape. Now i have a midsize grip to match my other clubs.

This was literally very helpful. Cheers!

The heavier the wire, the less it bends. I use a piece of bailing wire and lighter fluid. Did a video similar to yours several months ago. No music, no editing. 130,000 views. Crazy!

I have been using Comet for years to clean my grips ( I am 80 yrs. young , lots of experiment & found Comet the best with scrub brush .

Really good video, Never even thought about cleaning my golf grips

Great idea! Broke my 4 wood and just had a new jumbo grip installed. So I’ll save it for my next one. Thanks for the tip!😊

That's going to save me a few bob, thanks.

Awesome! Will be doing this! Thanks

It does look like it will take a while if all that is required 13x

nice one mate cheers

I appreciate the video. Very helpful advice for those of us that would like to do some of the work ourselves, but don't want to buy a bunch of specialized equipment. I am going to give this a try tonight.

spirit level is a great tip, thank you

Thanks. You were lucky that the cap unscrewed. I'm going to check the one I have to see if it does the same. I hope so. Yes, good blade and make sure not to cut into the fibers. Part of the reason why I like metal shafts. :)

Thanks for watching, I hope this can help you tell if you have a fake taylormade m6. I appreciate that my test versus an M5 is not a perfect test, it is meant more as guide for comparative.

WTF is white spirits?

A well-done explanation of the whole process. A hook blade cutter makes short work of removing old grips. Heating up the old tape with a hair dryer softens the tape and makes it much easier to peel off in most cases. A bench vise and a rubber clamp to secure the shaft makes the alignment process much cleaner.

Do you think a pot of boiling water would loosen the tape up?

Googled how to regrip my putter and you came out top mate! Have to bring it round to you if I have trouble. 😂

He had done this “hundreds, - if not thousands - of times before”? Hmmm, that was some battle with the old grip and tape...😳🤣😂🤣

ooo no!! mate use a heat gun or blow torch it will fall off.

The level is the key. I've got three putters I have to regrip because they're off just a hair. But then, maybe that will help my putting,.

Use a heat gun to heat the tape and then peel it off really easy, no chance of damage (and critical for graphite shafts)

You can remove the tape by using a small heat gun. Move the heat gun back and forth slowly about 3-4 inches above the shaft for just a few seconds. Wait until the tape cools and start peeling. Keep repeating the same process until all the tape is gone.

Thanks. I'm new at this new grip thing so your video will help a lot.

perfect.

let me give you one of my tricks to put a putter grip on....use your phone it will line the grip on perfect not 1 degree one way are the other perfect these phones is awesome..1 degree off you will miss putts all day long over like 8 feet..my new putter is off from factory even it says 34 inches its not even 331\2 inches long from factory.no man eye ball can't put a grip on there perfect dont matter you done thousands of grips one degree off will cause you miss putts

going to use me cloths hanger to take my putter grip off they like 30 dollars cost to much to just throw away in case i want to put it back on cause new grip didnt work like i thought it would work

This is not a regrip. There is no old grip to remove so it's a grip addition

I can't get the grip to slide in at all, very frustrating. 😫

Quick & easy, no messing. Nice vid

cheers mate, I didn't realise the new grip just slides on I thought it would need some coaxing.

Dude, you've shamed all others with this video... a no non-sense, straight to the point and effective, re-grip video.... love it.

What is white spirits?

what sort of fluid do u use ?????

Nice video. Short, concise and to the point.