Відео

How much energy storage 🔋? 52kWh in a Volkswagen battery pack? That is still fairly small

Fronius is solar inverter but Victron multi plusses are not solar inverters so do not do any work in that situation.

Uuuuuhhh you are doing well brother but please can I run my motors of 20HP and one of 15HP in day and night can you give me a setup and you can supply for me I'm African Tanzania country

👍👍👍👍❤❤

Hello from USVI, thanks for the video.

I would like to purchase one , dose your bms have a comunication cable to the inverter

Perfect job and thanks for sharing🙏 I like the tidiness and versatility and I only one question about the 250/100 MPPTs cables, you've used 50mm and said that it is compulsory whereas I was under the impression that 35mm was the recommended size. I wanted to use 50mm on both my 250-100 since I always oversize all of my cables but I didn't think the 50mm lug would fit the MPPT connector, so I used 35mm instead. I only have two 5000 Victron inverter as I do not need three-phase although I've considered that.

GREAT VIDEO VERY EDUCATIONAL. LOOK FORWARD TO MORE .

Interseyting about the first picture of the BMS Lynx .. It seems new product ? (with both grilled top and bottom )

Yes highest is the air lame , the better is the ventilation and so the better is the yield ! the fact is also the cooler one are inclined so the air lame may create a bottom-> top flow and more cooling vnetilation .. Whereas the hotest is flat (seem full horizontal ;-) .

What is your Frponius SYmo Power ? you produce almost 15 kVA on it...

Yo ! Free Space around one inverter is preconised at 30 cms (top/bottom/side) ... That means free space for cooling between 2 inverters should be 60 cms .. It does not seem that is your case, especially with your Power factor charge (always Full power ?).. Another stuff ... It depends also of your ambient temperature ... Max Power avalaibility decrease if ambient temperature increase ... Down to 7000W for each Multi10000 at 40°C

Very smart system sir 👍 👏

Sieht gut aus habe auch alles von Victron 🤗👍🤗👍

Does replacing this part require programming or computer matching?

Great Setup, the explain very helpful thank you for sharing

Looking damn nice

Slow down buddy

Where is that Beta on the www ?

Hello, Planing on buying one, i'm off grid, no ac grid in. Is this device able to throttle the charge amp depending ont available solar and without using the battery...just with solar excess..? Thanks.

NOw is this system cheap. But a few yeas before this 10 000 VA units was expensive. Also battery now is cheap. 60 kWh battery is about 5400 €.

I think you missed the 500ma Fuse which Victron recommands.

How long to charge?

What screen do you.use?

Beautiful!

Please the installation

Love this product ✅✅

Is there a smell?

Hi, greetings from Australia! I had to turn captions on and slow the video down to 75% speed to understand it, but this is an excellent video for an explanation of the Easysolar. You don't need to apologise for your English - it is much, much better than my Romanian!!

No idea what he said, accent to heavy

Nice Setup looks great like the cable Management very good and clean,greetings from Germany.

the main drawback is the price the price of 1 Victron inverter = the price of 5 Chinese inverters with the same characteristics - which are also combined into a single network

I don't understand a little think... I so a lot of PV system that use e separate MPTT and it don't use the internal MPPT of the inverters... Why this please ? I'll have a 90 pieces PV panels on my new home roof... and I must decide how to divide them... Faina de tot instalatia, mai ales managementul cablurilor :-)

damn, this system bangs chicks, not gonna lie....your house must be very powerhungry if it needs this bad ass system. really liked the explanation, what a powerfull system

What's the part number for this part?

Great video! I'm looking at one of these units for a campervan. I have 2 questions; do the AC outputs need a breaker switch to be safe or is there one already installed in it? And 2, how many solar panels can be attached to it? Greetings from the netherlands!

Victron makes excellent equipment but wish they would embrace conduit knockouts so the wiring isn’t exposed. But, beautiful job on your wire management on this build. As clean as I’ve seen.

Great setup! very clean. Question, did you think about the maximum disconnect current the mega fuses can handle? Lifepo4 can deliver tens of thousands of amps in a short. Ive read that Class T is better for this?

greetings from GREECE!! a very good development of victrom

What a really nice setup !! Pretty and so powerful. I made a triphasé system but only with 3x 5kva Multiplus 2 and huawei inverter. Made the batteries myself with diy kit was cheaper and really good with seplos bms about 1600euros for 15kwh (we have 75kwh)

My friend, what the unit name manufacture thank you

Great, but next time turn the fuse over, then you can immediately see whether it is still intact or defective

I plan to install two ev chargers together with Cerbo and Smart meter(at grid input), is it possibile to configure the system with power sharing between EVcharger1-EVcharger2? The home will have the highest power priority.

Super system, well done, Im a bit jealous :-). Beautifully connected. How does the Fronius throttle down (delivering less power when the grid has a failure, no power from the grid) and your batteries are full (SOC 100%) ?? are you using zero feed in from Fronius ? to prevent overloading the batteries ?

Hi! Any possibility to work without battery?

Please provide all the links for the custom Tesla S battery cart, the bus bars used to convert the batteries to 48v, and to put them in parallel, and Etc. that you used in this video. For my project I’ve purchased 18 Tesla S modules, an EG4 18KPV Hybrid Inverter, Vero BMS V2, and 31 Hyperion 545W bifacial solar panels. Thank you

What is the name of the app you used to test the Tesla S Modules (batteries)? The transcript showed “Piloff”, but it doesn’t exist.

I liked the video, but I would to see a video on how to connect to to my damsung S24+. I've had the system over 3 months and can't connect to my phone.its working my batteries are charging 13.8.so I'm wondering why I need to connect to cell phone

Hello from Switzerland :)

I miss an option to charge EV without draining battery. I can put it on AC IN but than I loose statistic. Also auto mode does not work on AC In.