Відео

Thank you! Don't forget that you don't need to change like ever ;) just remember to rinse and clean it after some time

Bruh you sound dumb 😂

I mean if you cant unscrew 2 screws then don't buy it

Looks like more than 2 screws

the audio was quite bad there but its 15mm

to be honest I only did the rears in the video and it probably took me about 1,5-2h from start to finish and that is with filming and looking for tools etc. If you have all the tools that you need it should take about 40min ish (for the rear). The front requires a little bit more work but if I had to guess probably 3h should be more than enough for all the work together. Good luck! 👍

yoow your not the only one, mine was oily too. i dried the excess with a cloth before i install it. It caused my intake to smoke

No big difference from stock to be honest

I guess it's a thing now right 😜

Class 😂

Thank you! I haven't had any issues with it so far (but that's good to know). The music is LWKGD - Sorry

nice bot comment, you already say this on another video

Hello! To be honest I haven't felt much deference although I don't drive a lot on rough roads. I think a lot has to do with the wheels and tire profiles så on smaller tires of course you are going to feel more all the imperfections of the roads etc... :)

I guess you are right mate, I have seen some good reviews about green filters as well 👍

to be honest I haven't done the fronts just yet because it is sitting just right with the tires that I have on, when the time comes I will be changing to a lower profile tire and than change the springs

@@esauto1219 i just attempted the fronts on mine. Such a pain. Didnt succeed

@@ahmadriyad07 thank you for replying back, did you have all tools that you needed? It's always good with som extra help ☺

No u don´t need to do that

I just did the same to my car, the bolts were not actually torqued very much whatsoever, the hardest you could tighten by hand are sufficient.

it may be true but the throttle response was much better ☺

no rubbing in normal cases, but if the road is bumpy and if I have grown passengers in the backseats than yes you can hear it sometimes. as I mentioned in the description these are OZ racing rims with tires 245/40/19 in the front and 265/30/19 in the rear. I think these may be 9x19 in the front and 9.5x19 in the rear (I am not completely sure about that).

actually 15mm, this is my daily driver and with the new wheels I wasn't sure how low I could go. I have to drive through some bumpy roads quite often and this setup has worked perfectly well for me

it is more stable on the road probably because I have wider tires than stock but I feel the difference 👍

Sounds good mate, I do have a stage 1 tune on my car which might affect the performance a little but I hope you get some good results as well.👍

Hi! I have had no issues what so ever since I replaced the filter, you just need to keep in mind that you have to clean it after a while. 👍

As far as I know you only need to mist the filter with oil when you take it out to clean it, the filter comes already a little bit wet/oily when you take it out from the plastic bag. 👍

Only after cleaning. New filter comes oiled

so oil helps capture dust I would suppose?

All the filters come pre-oiled from factory, you also don't want to add more oil as this can be sucked into the MAF sensor then give you some issues. Only apply minimal oil if you do clean it.

no it has oil on it..... then leave it alone .. to much oil will destroy the mass air flow sensor.

I'm still very happy with the result, nothing has changed 👌

no, I think all the facelift models looks like this 😊

How so?

www.autodoc.se/kn-filters/7278517

I know mate, I have been busy working on our house and a little bit on the go kart but I will be filming a new video very soon about the Cla stay tuned ✌️

@@esauto1219 nice one. Look forward to it. I also have a CLA so will stay subbed for ideas 👌🏼

I´m not sure but I guess yes, because when I am on sport mode the car becomes much stiffer

That is common on most 4cyl turbo engines. Even a few I6 and V6 engine sedans I have owned make the ticking lifting sound.

@@VanquishMediaDE yeah, my 2.5l I6 m54 and and 3.7l duratec ticks from the hydraulic-lifters too. Comes with the territory ✌🏽

Thats normal on these german beautys because they dont know how to engineer a solid engine. 🤣🤣

Lmao

It’s a diesel

I realised that when I was editing the video 😅 I will change it back. thank you for informing me 👍

Hi mate! First of I have a stage 1 tune on my car (to increase power) and I can't tell if there would be any difference in the fuel economy if my car was stock, but as it is right now I can't see any difference in the fuel economy at least nothing I have noticed or thought about 😊 I think there is other things to consider if you want to lower your fuel consumption like service etc..

@@esauto1219 where did you get your tune from ?

@@noahmurillo6048 I got it from a local company near me, they don't have any social media unfortunately but if you are going to tune your car there are some companies that can reach 200+ hp with stage 1 only since the engine in cla 200d is identical with the cla 220d 👍

Yes it has to, and if you have stock wheels on your car I think you can go even lower than 15mm :)

@@esauto1219 oh ok because some other guy says cannot because of the weight of the 4matic...too heavy for that spring

@@jannacino5495 hmm 🤔, I may misunderstood your question, I am not sure if the same springs that I used are going to fit for sure for the Cla-4matic, but I know for fact that there is other springs that should work for your car, H&R have springs for the Cla 45 AMG (it is 4matic as well). 😊

@@esauto1219 i just called the customer service they said it will fit but the springs need to be more stiffer because 4matic is heavier than the cla45 and others.

@@jannacino5495 alright mate thanks for the information :)

Hi! I have stage 1 on my car, I did it before installing K&N air filter but I never dyno my car so I can't give you some correct numbers but they said from 136hp-170hp and from 300nm to 350 or 370nm (I think). I definitely think that stage 1 is safe for every car. I see stage 1 as with how much hp/nm the car should have come from factory. I hope you got the answer ✌️