Відео

@shawn.collisionrepair do you know what the bolt is called that you called out to NOT drop? - sincerely someone who did drop it

What electrical parts do you have to disconnect so the batterys don't get damaged when you weld .or dp you even have to disconnect anything ?

is there anywhere to rent the Xpress 800 gun lol becasue it costs $30,000 lol

Thanks for your video, this saved my ass

Great video dude. Straightforward and to the point - just how us techs like it.

Nice to see someone repairing a car properly!! Attention to the small detail noted I.e all the small brackets repaired/replaced and painted 👌🏼 there are the small bit people normally bodge well done

Did you run the rear motor fluid drain from the service options? Or not needed?

What about the Paco on the right side of the right side strut

I tried to slim Jim the door and dislocated the handle can it be reconnected thru the same handle hole ..if the connection clip isn't broken?.

Your car will mostly have a windshield, make sure you have a slim tool for the front dash speakers…

Shawn, where did you get that hood emblem alignment jig?

Should have upgraded the front bumper while it was off.

Great video! I have to replace sensor #12, which is the sensor closest to the rear drivers side wheel well, if I remove the clips and pull up the liner would I be able to access that sensor without removing the bumper? Thanks! 🙏🏼

Great Job

is this pretty much the same for the passenger side?

Excellent workmanship...I wish you were in Seattle :)

Why you didn't change both sides? That doesn't compromise the handling?

Did a rear bumper tesla model3 2021 (with parking sensors) will fit on a 2023 without these parking sensors . Thanks

Did a rear bumper tesla model3 2021 (with parking sensors) will fit on a 2023 without these parking sensors . Thanks

I definitely didn’t drop the nut on the door I’m just asking for a friend but hypothetically what if you did drop the nut in the door what can you do to get it out?

I had a door that was rattling (sometimes) and the first screw I went to undo....it was loose. Tightened it up and hoping for the best.

ouais ils ont fait fort!! montage simple mais efficace!! A déposer comme a reposer un jeu d enfant !!! je suis en train de démonter une modèle trois !! que du bonheur!!

hi, great video. Is there a video for the model 3 highland?

do you havel to disconect the electric battery to replace the 1/4. if yes how do you do it.

Everything is good but i think used wrong rivets

퍼티도 잘발라야 하지만 샌딩시 높낮이 단차 갈아야 하고 조색을 잘맞춰 뿌리고 건조후 투명 뿌리고 열처리 잘해야

Did you replace the drive motor bushings?

Hey man, great vid. What do you do if the self braking says it is not working after replacing the bumper. Could this be just a wiring issue?

Hey Shawn, what would the pricing for this kind of repair be?

i’m pretty sure my car has the exact same damage, is this all the car needed?

Beau travail, bravo et merci

tres bien montees ses tesla !!! faut en prendre exemple un enfant pourrais le faire !!!! bravo les ingenieurs ingenieux !!!!!les longerons avec demi longerons boulonnés top les traverses tout est tres bien pensé !!!! punaise les ricains sont costaut les portes les leve vitres les panneaux ouahhhhh quand on pense a peugeot hahaha meme les allemands sont lachés !!! la ca me plait je viens d en acheter une tesla accidentee tonneau rien a bouger le toit les montant un peu plats la quincaille devant out mais les tourelles le chassis apres faux longerons rien !!! ca me botte

Where can we buy those eraser's wheel?

What is the cost of this? I need to get this done on my Model 3. Thank you

When I got my car wrapped they didn’t mark it and I can’t figure out the right placement

Bro where do u get that tool from

Hi! So for the camera in the middle of the fendor, is the camera attached to the car or is it able to be pulled off? After the fenders replaced can the camera still work if it wasn’t originally damaged?

Where can one buy one of those jacks with the jig on it? Is it from Tesla?

That was so cool!

Where can i buy parts for my tesla model 3?

Currently watching this cuz it just came in the shop and I got it 😭

Андрій , ось так має бути відновлення на джигах.

Quality repairs done with quality equipment!!

Sweet! Thanks for the video. It takes longer to gather the tools than remove the light. My light had a weird blue circle fabric piece covering the weep hole. My light had a bunch of water that built up over the last few months. I removed the fabric and dumped the water. I left the fabric off and reinstalled the light. I’m hoping for some sun tomorrow to bake the water remaining out.

Thank you for sharing valuable experiences!!!

What kind of drill bits are you using because mine are dull after two or three holes

Thank you!

Also did you have a tesla diagram for what needed to come off? I have. 2019 all im seeing online is the current 2024 model teardown

Is there anyway to do this with the windshield still in place.?

So, no need to blend the paint on the passenger side door and hood?