OneGauge Can Bus Communication for your Aftermarket ECU

[@Custer-23]

So if we are using CAN bus to connect with a Holley Terminator x are we good to use sensors that are compatible with Holley and just set the parameters for the sensor inside the Holley ECU and then it will send signal through can bus to the digital display? Or would we also need to set the parameters inside the OneGuage for it to give accurate reading?

[@TheOneGauge]

It will depend a little bit on the application, but usually it's easiest to set up custom sensors in the onegauge directly. The Holley protocol is unique due to the amount of data it sends and how fast it sends it, so it's best to wire up additional sensors directly to our hub.
Happy to go into detail though and discuss options by email!
Happy to go into detail

[@justinmalbrough3754]

Is there an option for the can module only without the hub?

[@TheOneGauge]

No, the can module can't do anything by itself without the hub. The hub is what does all of the computing work.
We do have a smaller version of the hub that we used to use though, if size is the issue.

[@justinmalbrough3754]

@@TheOneGauge ok what is the price on the smaller hub?

[@TheOneGauge]

​@@justinmalbrough3754Shoot us an email, we might be able to do a discount but it will depend on what all you need.
[e-mail]

[@albertkroon8855]

Kan je dit ook op een boot aansluiten

[@TheOneGauge]

Yes, we have done many boat products

[@dmedeiros1974]

do you have support for ecumaster black ecu?

[@TheOneGauge]

Yes we do!