I show you how to change the blade on the Einhell TC-SB 200/1 bandsaw and then tell you if you should buy one. #einhell #bandsaw #carpentry #woodworking
I still think there is 2 issues at play: The table top bandsaw is just 250w and might stuggle with rip cuts. The new blade is more of a cure cutting one than ripping. You could try a 1400x6.35 4TPI blade. 🤔 I have a 750w Einhell with a 3 TIP blade for rips, still I go slow to avoid stalling or drifting.
Jup, life is a learning curve. And of all saws (I own about thirteen), it's by far the trickiest to get cutting good. But when it does its job well, its unbeatable. I cut some 17cm thick pine in half to small speaker stands. Out of the thirteen saws, only maybe a handsaw could have made that cut... 😁
I still think there is 2 issues at play:
The table top bandsaw is just 250w and might stuggle with rip cuts.
The new blade is more of a cure cutting one than ripping.
You could try a 1400x6.35 4TPI blade. 🤔
I have a 750w Einhell with a 3 TIP blade for rips, still I go slow to avoid stalling or drifting.
Good advice. Thanks. It's not souch the stuff I don't know, it's the stuff I don't know I don't know.
Jup, life is a learning curve. And of all saws (I own about thirteen), it's by far the trickiest to get cutting good.
But when it does its job well, its unbeatable. I cut some 17cm thick pine in half to small speaker stands. Out of the thirteen saws, only maybe a handsaw could have made that cut... 😁
Hello, your blade guides are set wrong. the guides must be as close the the blade as possible but without touching it.
16:50 Chinese industrial music for the West….🤪😂🤣😂🤣
I think that for this kind of straight cuts the blade should be fatter so 1400mm x 8 and more mm in width and more teeth’s…