Yeah I was a bit careless with my fingers but there was no fingerprint on the lens after so all good 😊 yeah they have two different props, by spinning in opposite directions on each side the lateral torque is evened out across two axis rather than one which makes them fly with a lot more stability, which reduces the load on the microprocessor significantly (and therefore better battery life)
That's a bit of a problem, ideally you'd replace the motor I guess. What you could try is dab a really small amount of super glue on the threads but you are going to need to be very careful or you'll gum up the motor.
😀 Thanks for sharing. Instructions are clear.
Interesting,I wasn't aware there where 2 different props.
I think I will leave the gimbal cover on when I do it.
Yeah I was a bit careless with my fingers but there was no fingerprint on the lens after so all good 😊 yeah they have two different props, by spinning in opposite directions on each side the lateral torque is evened out across two axis rather than one which makes them fly with a lot more stability, which reduces the load on the microprocessor significantly (and therefore better battery life)
Whats the solution for strip screw? I got one thanks
That's a bit of a problem, ideally you'd replace the motor I guess. What you could try is dab a really small amount of super glue on the threads but you are going to need to be very careful or you'll gum up the motor.
how did yours break? Mine broke mid flight :( trying different props now
I was trying to fl inside and too little light, it veered sideways and suck some fabric into the prop!