Fork Seal Replacement on a Yamaha WR 125 Motorbike
Вставка
- Опубліковано 22 жов 2024
- Today we encounter a typical Yamaha fork issue when replacing the seals on this WR 125 Motorbike.
Below are links to some of the tools you will see us using in our videos:
Chain Alignment Tool
www.amazon.co....
Milwaukee ½” Impact
www.amazon.co....
Wurth Spray Pump Bottle
www.amazon.co....
Universal Fork Seal Driver
www.amazon.co....
Oil Drain Pan
www.amazon.co....
Magnetic Bowls
www.amazon.co....
Magnetic Pick up Tool
www.amazon.co....
Seal Pick set
www.amazon.co....
Kneeling Mat
www.amazon.co....
Rear Paddock Stand with Forks
www.amazon.co....
Rear Paddock Stand Cradle Adaptors
www.amazon.co....
Front Paddock Stand
www.amazon.co....
Nice work Steve, I didn’t know that the seal you could see was just a dust seal
So many folks ignore the state of the dust seals. They don't realise they protect the oil seals from crap. I use a ring of red rubber grease on the stanchions and pump it into the seals. Helps reduce stiction too.
Bit of 400 grit horizontally around the stanchions and some carnauba wax will help them last a bit longer.
That new mic on your shirt sounds good! Much better than before
Thanks, we’ve still found it to be a bit poor in certain surroundings, which you’ll notice on some future videos, but we’ve made some more improvements since to hopefully overcome this 🤞
Thanks Steve for sorting her out👌🏼
Really great video! Thank you 👍
In case you do have pitting on the the forks use a plastic milk container cut a strip of the plastic container wrap it around the top of the fork then place to fork seal onto the plastic container then slide both down the leg so you pass the pitting then slide the seal off the the plastic container strip
Into place
from where i can buy?
If you are struggling with undoing the bottom bolt of the fork leg when the fork leg is still complete try to undo the bolt as it with hold it still and not spin around inside
If he was a mechanic he would of known that.
How did you put the oil in? Just tipped it in from the top before putting the final cap on?
Yes. It needs to be the correct amount but yes
@themobilemotorbikemechanic thank you matey. Could I buff the pitting marks off my forks with 2000 sand paper?
How much do you charge to do fork seals
The price depends on what bike you have and where you are located.
@@themobilemotorbikemechanic yamaha WR125X and woking surrey
Sorry we are based in Warwickshire and do not cover your area
@themobilemotorbikemechanic that's OK no problem thanks anyway 😊
👍
I've always rubbed my pitting with aluminium foil, it's harder than the rust and softer than the chrome...