I am so sorry for the delay. I did not see the msg and the new software did not point it out to me. I have since fixed the issue and am now able to reply. I am not sure if you still needed help with this but if so, I would recommend that you go with an Ender 3 to start with. They are pretty tough machines and are work really well in all conditions. I have found them on ebay for under 100.00 and I believe that Microcenter has coupons so that you can walk in and get a new one for under 100.00 Again, very sorry for the delay to your msg. Hopefully the issue on my end is now resolved.
Do you know what dpi setting you can use with the 8170 when sending scans to card dealer pro, refractor cards look terrible at 300 dpi, but when I increase to 400 dpi, cdp will not process the scans.
Any recommendations for entry level 3D printers and necessary software?
I am so sorry for the delay. I did not see the msg and the new software did not point it out to me. I have since fixed the issue and am now able to reply. I am not sure if you still needed help with this but if so, I would recommend that you go with an Ender 3 to start with. They are pretty tough machines and are work really well in all conditions. I have found them on ebay for under 100.00 and I believe that Microcenter has coupons so that you can walk in and get a new one for under 100.00 Again, very sorry for the delay to your msg. Hopefully the issue on my end is now resolved.
Do you know what dpi setting you can use with the 8170 when sending scans to card dealer pro, refractor cards look terrible at 300 dpi, but when I increase to 400 dpi, cdp will not process the scans.