Sounds great! What is the total length of those exhaust cans? Im looking for the full length from the rear tip sticking out of the tail to the end of the inlet that slides onto the Y pipe? Thanks mate
I know obviously the video was sped up slightly, Realtime how long did it take? Is it easily done for someone who’s only done one exhaust on a zontes 125u before?
Hi mate. What where the size of the sockets, hex, or anything else you needed to use to fit this exhaust. Can't find anything out online. I want to have it all here when mine arrives. Thanks.
Yes I agree. I think I am going to have to put the baffles in. After taking it for a morning ride of a few hours, I think i is just a bit TOO loud. I do like the sound, but the volume just needs lowering a little. The look is 1000x better than stock IMHO.
Thanks for the video, I had to rebuild the back end of mine because it was missing the whole backend when I bought it, looks great now.
Glad I could help
Sounds great! What is the total length of those exhaust cans? Im looking for the full length from the rear tip sticking out of the tail to the end of the inlet that slides onto the Y pipe? Thanks mate
About 32cm
I know obviously the video was sped up slightly,
Realtime how long did it take? Is it easily done for someone who’s only done one exhaust on a zontes 125u before?
Give yourself a few hours then. Better to do it slow and get it right than trying to rush it.
Hi mate. What where the size of the sockets, hex, or anything else you needed to use to fit this exhaust. Can't find anything out online. I want to have it all here when mine arrives. Thanks.
Think it was 10mm sockets, you know the ones that always go missing. Hex wise not sure, I just have a set and try each one till it fits.
Where did you get that bracket that mounts on to the fender and holds your exhaust up? I bought and exhaust and it needs one of those
All the parts I used were supplied with the exhaust kit. Check with the supplier if you are missing a piece.
Who is the distributor? I need this for mine! I am in Melbourne
delkevic.com.au/Yamaha/FZ-6%20FAZER%20/2009/yamaha-fz6n-fz6s-fazer-04-10-200mm-round-stainless-exhaust-system.html
Man I've bought one of these and it really doesn't make sense. There are no clamps. Just springs and round connections
As in no clamps to attach the exhaust to the pipe, or no clamps to attach to the bike?
🍻Sounds like it broke the mic👍
Yes I agree. I think I am going to have to put the baffles in. After taking it for a morning ride of a few hours, I think i is just a bit TOO loud. I do like the sound, but the volume just needs lowering a little. The look is 1000x better than stock IMHO.