Hi: Been away for a couple of weeks. You should be able to by setting the trigger points in the module setup screens. Not something I have ever needed to try.
@@abplctestbench759 Thanks for the answer. I will to make a migration, from a SLC 500 to ControlLogix. The SLC have an Omron E6B2-CWZ5B encoder, an encoder interface (JB-218) and the conection to the HSC module (1746-HSCE). I need this encoder interface to conect it?
@@alvarojimenez1922 Hello - Yes the 1756-HSC is the CLogix version of the SLC 1746-HSCE. I am not familiar with the Omron encoder, but would think that the interface is needed to get the same or better results in the CLogix.
Hi, do you have any video or code that you can send on how to create a virtual axis through an encoder that enters an HSC module and then gear it to a real axis of a Kinetix 6000. Regards
HI Fernando: Sorry I have no idea about anything to do with Kinetix. Have never worked with them and don't think I have ever seen one. Wish I could offer more help but not within my abilties.
Hello Leslie: Thanks for subscribing. I have never done any research on that. I will put it on the board as a subject for a video topic. Possibly ask on PLC.net. Link is near the top of the page in the banner.
Thanks for the help pal!
Glad I was able to put something up that was helpful for you. Your welcome
Great content! Thank you
You are welcome - Hope it helps.
Hi...
Where do I find Range12To15[0]?
Hello:
I am not quite sure what you are asking.
Can you please explain a little more what you are looking for.
Thankyou
can i use the 4 outputs of module for pulse output train
Hi: Been away for a couple of weeks.
You should be able to by setting the trigger points in the module setup screens.
Not something I have ever needed to try.
Great video. I have doubts about the connection of the 1756-IF8 module. I would like to connect voltage and current. Sir, could you help me?
Hello Julio:
I will put it on my to do list but will be a week or so before I can get around to it.
Thanks for the video, but I have question. I have an Omron E6B2-CWZ5B. How can i conect it to the 1756 HSC module?
These are Allen Bradley/ Rockwell automation cards. They are not compatible with Omron.
If you are using an Omron system you can only use Omron cards.
@@abplctestbench759 Thanks for the answer. I will to make a migration, from a SLC 500 to ControlLogix. The SLC have an Omron E6B2-CWZ5B encoder, an encoder interface (JB-218) and the conection to the HSC module (1746-HSCE). I need this encoder interface to conect it?
@@alvarojimenez1922 Hello - Yes the 1756-HSC is the CLogix version of the SLC 1746-HSCE. I am not familiar with the Omron encoder, but would think that the interface is needed to get the same or better results in the CLogix.
Hi, do you have any video or code that you can send on how to create a virtual axis through an encoder that enters an HSC module and then gear it to a real axis of a Kinetix 6000. Regards
HI Fernando:
Sorry I have no idea about anything to do with Kinetix. Have never worked with them and don't think I have ever seen one.
Wish I could offer more help but not within my abilties.
How do you see AB 1794 -ASB I/O,using RSlogix 500
Hello Leslie: Thanks for subscribing.
I have never done any research on that.
I will put it on the board as a subject for a video topic.
Possibly ask on PLC.net. Link is near the top of the page in the banner.