Thank you for posting this good information!!!!!! The kits with the large regulator cost as high as 350 and are not needed if you're running natural gas or propane with a regulator, I scored a 5000w generator for less than a hundred from my neighbor because it needed a carb rebuild. It's really hard to justify rebuilding some carbs, especially when you can do this upgrade, Great video.
V Power Equipment, This was the only video that actually explained that this is a low pressure flow control carb, Not a high pressure regulator that nobody needs anyhow, I spread your information on Amazon, Thanks again!
I installed this on my Generac gp8000e and it runs like a champ on propane and gasoline.. haven't tried natural gas yet but have no doubt that the genny will run .
Have any video's using this on Natural Gas. I haven't found a single video review with this Carb running on Natural Gas make's me skeptical of buying this Kit.
So . would i be able to use this and hook into the natural gas at my home to run the generator . Would i need a regulator or anything other than this tri fuel carb.
The issue I have with my own, when the gas pressure is very low, and I turned on my AC, the generator begins to jerk and voltage fluctuates. The generator is a 3.1kv. Also, when the gas cylinder is filled with gas to capacity, it runs the AC well. So does the gas pressure level affects the voltage the generator produce?
@@efeanderson689 Something I found, when the cylinder gets close to empty, the pressure drops causing your air fuel ratio to become erratic. A way I found around this is to put the cylinder in a basin or something and then pour boiling water over the cylinder (2 liters or so). This will then raise the pressure inside the cylinder
yes the bowl will have gas in it some times the generator will drain that bowl first and sometimes it will just start running on LP. So if you are storing the generator and have run on gasoline we recommend draining the bowl
Sir i have company fitted same dual carburetor. My problem is how to adjust gas setting when i switch it to CNG fuel supply get low but if i move it little towards lpg than fuel get stable supply. Please need little guid for this 2nd thing my generator keep missing in startup but get stable after few mints
Thank you for posting this good information!!!!!!
The kits with the large regulator cost as high as 350 and are not needed if you're running natural gas or
propane with a regulator, I scored a 5000w generator for less than a hundred from my neighbor because it needed a carb rebuild.
It's really hard to justify rebuilding some carbs, especially when you can do this upgrade, Great video.
There is a set of screws in the control knob to fine tune the unit however I must say it is almost always not needed
V Power Equipment, This was the only video that actually explained that this is a low pressure flow control carb,
Not a high pressure regulator that nobody needs anyhow, I spread your information on Amazon, Thanks again!
I installed this on my Generac gp8000e and it runs like a champ on propane and gasoline.. haven't tried natural gas yet but have no doubt that the genny will run .
Of all the instructions on You Tube this is withjoiut a doubt the best and easiest to follow. Thanks, PR
Didn't show how natural gas is hooked up
You guys are the only ones that have the carb kit for westinghouse 7500 watt gen thanks !!!!!!!!
Just ordered this still waiting for it to come in the mail. Looking forward to upgrading my generator.
Have any video's using this on Natural Gas. I haven't found a single video review with this Carb running on Natural Gas make's me skeptical of buying this Kit.
Thank, you answered several questions. Good video
Would this work to convert a propane grill to a natural gas grill without having to switch out the orifices?
Hi,
just purchased, for natural gas, is there a quick connect available to attach to the carb? thanks
So . would i be able to use this and hook into the natural gas at my home to run the generator . Would i need a regulator or anything other than this tri fuel carb.
Looking for this conversion for briggs engine 5.5kw sold as Troy built. Great presentation! 👍
sorry we don not have one
Informative. Thanks
Good info, thank you!
i have a question what if you get a surging situation when running on propane after you have done the setup. but it runs fine on gasoline .
What thread pitch is the brass fitting with the hose barb on it, that the propane line fits on?
Thank you for the video. Please could you indicate the regulator pressure for the LPG side?
no higher than 1psi about .47-.55
The issue I have with my own, when the gas pressure is very low, and I turned on my AC, the generator begins to jerk and voltage fluctuates. The generator is a 3.1kv. Also, when the gas cylinder is filled with gas to capacity, it runs the AC well. So does the gas pressure level affects the voltage the generator produce?
@@efeanderson689 Something I found, when the cylinder gets close to empty, the pressure drops causing your air fuel ratio to become erratic. A way I found around this is to put the cylinder in a basin or something and then pour boiling water over the cylinder (2 liters or so). This will then raise the pressure inside the cylinder
6:35 When you talk about switching from Gasoline to LP, isn't the float bowl still full of gasoline or does the switching process bypass the bowl?
yes the bowl will have gas in it some times the generator will drain that bowl first and sometimes it will just start running on LP. So if you are storing the generator and have run on gasoline we recommend draining the bowl
Does your westinghouse 7500 kit support the 12500starting/9500running as well?
sorry it does not we do not have one for that generator
What happens if you accidentally have both, gasoline and NG flowing to it?
not 100% sure but I think the generator will stumble and stall
Sir i have company fitted same dual carburetor.
My problem is how to adjust gas setting when i switch it to CNG fuel supply get low but if i move it little towards lpg than fuel get stable supply.
Please need little guid for this
2nd thing my generator keep missing in startup but get stable after few mints
Where can I find de calburator
How can we save the gas,if generator is consuming gas that is the hat I want to ask you sir
Do you have a conversion kit for a Westinghouse VH10000?
sorry we do not
Finally
More about tank regulators
Camera is too far away. Can't really see what you are doing.
Where can I buy a kit?
WWW.VPOWEREQUIPMENT.COM
any need,contact me.
I have a ai power 12000 it's a 459 cc how much would a kit cost? And do you have one?
I have a duromax dual fuel XP12000EH. Will it work on it?
Emailed never heard baxk