Phase 3 Part 2 Head and cams measurements

Hi everyone
In this video I remove the valves and bucket and shims and I take some important measurements info , I also torque the cam caps to see if there is any play in the camshafts, both inlet and outlet.
Hope you all fine it interesting as I did making the video .
Cheers
Gary

[@1coolwebsite]

Thanks for doing these vids Gary, I have a KZ900 engine I am about to start stripping down so interesting to follow what you are doing and finding, thanks

[@garyspracticalworkshop357]

Pleasure...hope it goes well

[@Pokemongold88]

Enjoying the videos gary ,beautiful myford lathe no micrometer lol😂 👍

[@garyspracticalworkshop357]

Thanks
Gary

[@garyspracticalworkshop357]

I can't find my mic anywhere since I moved , must get a new one.
Cheers....

[@garyspracticalworkshop357]

Your welcome. Gary

[@karlvanboxel561]

I don’t personally c the point of using a vernier to get a “ rough” measurement I’m always keen to get an accurate measurement for piece of mind

[@garyspracticalworkshop357]

Good news, found my micrometer