I am delighted to find your youtube video I managed to clean my cooker hood motor as directed .it took us a long time but finished and fan is working again much thanks .Delighted thankyou thankyou Val
Thanks my man! Mine hood is working fine just need a bit of cleaning and the fan making squeezing sound need lubrication for sure. Will update tomorrow
Thank you for this vedio as i was looking for motor similer to mine..Hotpoint Cooker HE62X Hood Impellor Fan. It is exactly same probably come from same manufacturer. This vedio helps me to understadn set up. I was able to clean the dity fans as original digrams does not tell full story
Thank you very helpful. Mine is not working, so I will start cleaning from tomorrow and will see how it goes. How to find on meter that motor is dead ? Or what is the first first step you take to find what is wrong with motor ?
If the resistance of the motor windings measured with a multimeter is too high, than there is probably something wrong with the motor. Of course you do that after unplugging it. Good luck.
Interesting. My 10 year old motor suddenly died while in operation. Wondering if taking it apart and cleaning will do anything. Can't buy a replacement motor without it costing more than a whole hood.
Is the grease you use regular vaseline? I currently have my device open, and the only thing i'm still unclear about is what type of oil/grease to use to unblock the (stuck but not dead) motor unit
@@TIRestoration i found a WD40 spray in the kitchen, some gear grease in a toolbox the previous tenant left, and it bleeping works again o.O thank you for the quick reply, from all four in this house!
I have a virtually identical motor but the springs are tiny. The motor axle is free to move up or down about 1cm and causing the fan to scrape against the housing. Any thoughts?
If it is the same it might be the nut in the center of the fan has come loose, you can adjust the fan up or down and tighten it well, you can also check the video at 10:40. good luck
The nut us tight. The issue is that the axle is free to move backwards and forwards along with the armature so that the fan hits either side of the housing.
i cleaned mine was working for 1 week and now has no voltage going to the motor but the lights are working fine. I will figure it out when i have more time . Any suggestions ?
This a single phase induction motor that has a capacitor in the auxiliary winding circuit to produce a greater phase difference between the current in the main and auxiliary windings. It starts with the help of a capacitor. Good luck
I am delighted to find your youtube video I managed to clean my cooker hood motor as directed .it took us a long time but finished and fan is working again much thanks .Delighted thankyou thankyou Val
Thanks my man! Mine hood is working fine just need a bit of cleaning and the fan making squeezing sound need lubrication for sure. Will update tomorrow
Thank you for this vedio as i was looking for motor similer to mine..Hotpoint Cooker HE62X Hood Impellor Fan. It is exactly same probably come from same manufacturer. This vedio helps me to understadn set up. I was able to clean the dity fans as original digrams does not tell full story
Buenas tardes yo limpié mi campana y cambie los filtros pero me hace un pequeño ruido q sera
Thank you very helpful. Mine is not working, so I will start cleaning from tomorrow and will see how it goes. How to find on meter that motor is dead ? Or what is the first first step you take to find what is wrong with motor ?
If the resistance of the motor windings measured with a multimeter is too high, than there is probably something wrong with the motor.
Of course you do that after unplugging it.
Good luck.
Thx bro
Does cleaning the outside of the motor with the wire brush improve its operation?
yes, the motor can then lose its heat better
Ahh yes ok, thanks for a very informative video.
Interesting. My 10 year old motor suddenly died while in operation. Wondering if taking it apart and cleaning will do anything. Can't buy a replacement motor without it costing more than a whole hood.
Sometimes it's worth taking it apart to see what could be the problem, before buying a new one. Good luck
Is the grease you use regular vaseline? I currently have my device open, and the only thing i'm still unclear about is what type of oil/grease to use to unblock the (stuck but not dead) motor unit
I used gear grease, you can use WD40 to unblock the motor unit and then grease or lubricate oil for the moving parts. good luck
@@TIRestoration i found a WD40 spray in the kitchen, some gear grease in a toolbox the previous tenant left, and it bleeping works again o.O thank you for the quick reply, from all four in this house!
I have a virtually identical motor but the springs are tiny. The motor axle is free to move up or down about 1cm and causing the fan to scrape against the housing. Any thoughts?
If it is the same it might be the nut in the center of the fan has come loose, you can adjust the fan up or down and tighten it well, you can also check the video at 10:40. good luck
The nut us tight. The issue is that the axle is free to move backwards and forwards along with the armature so that the fan hits either side of the housing.
I have packed this with a couple of washers to minimise the axle movement and it seems to work. Thanks again for the video.
Where this type of motor available. Can it be fitted in Glen chimney hood. please advise.
You can look on the internet or second hand market for glen chimney motor
Where did motor available
Which company chimney was it?
The brand name is Atag
App mughe bta skte ho kya sir mughe chiye
i cleaned mine was working for 1 week and now has no voltage going to the motor but the lights are working fine. I will figure it out when i have more time . Any suggestions ?
You can measure if the is a voltage going to the motor. Good luck
@@TIRestoration the termal fuse on the motor was faulty
Handig zo’n striptang he?
Is chimny ke moter or impeller chayes
Is impeller motor cooker hood
In this motor there is capacitor?
This a single phase induction motor that has a capacitor in the auxiliary winding circuit to produce a greater phase difference between the current in the main and auxiliary windings. It starts with the help of a capacitor. Good luck
@@TIRestoration How can we increase the speed of this motor ,mine is running very slow
@@live-your-way By increasing the supply frequency. Good luck
How can we check the capacitor?
Sir kha se milegi ye moter pls no de do
Bhai mili kya motor. Mi bhi yahi motor dhoond raha hu. 2 coil me mil he nahi rahi hi
Aapke mobile nabar
Sharab ke contact number
Sharab ke WhatsApp number
You don't have tools
Non funziona