Why does everyone on UA-cam take the longest way to do anything about piping? Eccentric's, t's, long or short ell's. Toss out that book you read on how to do it and use your head. I would have welded that before the video ended
@mechanicalfabrication786 I don't know about you, but a 6x4 eccentric reducer measures 6-5/8 +4-1/2. 6-5/8 minus 4-1/2 = 2-1/8. 2-1/8÷2=1-1/16. I have a piece of 8" angle that when clamped to my table is square to my table. Get a block or stack of metal 1-1/16, push the 6" side up against the angle and roll it, keeping it flat against the angle until the 4" end rests on the 1-1/16 stack. Measure from the table up the side and mark it at 3-5/16. There's your centerline.
Ap bohat hi achi video bnaty hain good sir
Very nice good information sir jee🙏
Mash Allah good job ustad❤
Bahut achcha video sar🎉🎉❤
Good job
Fantastic sir
Gap kitna rakty ha
Ager niche m kuch nahi hai only vartical pipe hai to kaise kare
Slipon ko kesy fit karty hn wo dikhao
Nice
Good
yaar scare kya hota hai pakistan ki bhi alag hi english pronounciation hota hai
Slip flange PCD. Pipe. Ka. OD. Par. Hota. Hai
i am working descon company 2012 in abudhabi ..saha gas
Why does everyone on UA-cam take the longest way to do anything about piping? Eccentric's, t's, long or short ell's. Toss out that book you read on how to do it and use your head. I would have welded that before the video ended
Hahaha v good
@mechanicalfabrication786 I don't know about you, but a 6x4 eccentric reducer measures 6-5/8 +4-1/2. 6-5/8 minus 4-1/2 = 2-1/8. 2-1/8÷2=1-1/16. I have a piece of 8" angle that when clamped to my table is square to my table. Get a block or stack of metal 1-1/16, push the 6" side up against the angle and roll it, keeping it flat against the angle until the 4" end rests on the 1-1/16 stack. Measure from the table up the side and mark it at 3-5/16. There's your centerline.
😂😂😂😂
👎👎👎👎👎