Hello, I am repairing dq200 mechatronics electronics. I want to test it in my own workshop, what kind of software and fault finding. I would be glad if you could help me.
As i know, DQ200 G2 can be (if you find correct software) be used in place 0AM927769G/K. No direct 'copy' possible due to processor differences (TC1766 in old vs TC1784 in G2 units)
As you see, unit have oil inside (sensor leak), additionally it have short circuit on plastic board. This short circuit was caused by TCU (controlling motor for hydraulic pump) so it means - whole this part is overheated. From my experience unit same as this make smaller or bigger problems in future. We do not like do same car more times. It is reason why in same situation we mount new unit or used - fully tested control unit with very low working counter.
Thanks for helping! I recommend it for all!!!
Hello, I am repairing dq200 mechatronics electronics. I want to test it in my own workshop, what kind of software and fault finding. I would be glad if you could help me.
on 2:42, it shows there is a dual wire for both +12V & GND. Is it parallel on both wire on each of it? Or separated on each other?
I see blue lines not violet. What about others pins on pcb? May be you have schematic diagram?
Hi what programs dovyou use we will know can you write
We use our tool called MechaProg
how to take old software to new tcm ?
yes, this video is about, how to get old software (and all other settings) from burned TCU and transfer them to new unit (or pre-used).
Есть ли такая возможность прошить плату без хвоста dq200 0cw и поставить вместо 0ам ?
As i know, DQ200 G2 can be (if you find correct software) be used in place 0AM927769G/K. No direct 'copy' possible due to processor differences (TC1766 in old vs TC1784 in G2 units)
Where is your location
Poland
Why did you not just fix the TCU you already found the problem
As you see, unit have oil inside (sensor leak), additionally it have short circuit on plastic board. This short circuit was caused by TCU (controlling motor for hydraulic pump) so it means - whole this part is overheated. From my experience unit same as this make smaller or bigger problems in future. We do not like do same car more times. It is reason why in same situation we mount new unit or used - fully tested control unit with very low working counter.
I have cople tcm dq200 to repair
Do you sell tcu ? Dq200
Actually they are out of stock.
@@mechasoft can you give me your e-mail address?
@@huseyinozyilmaz2944 info@mechasoft.pl
Kool and interesting video thanks, how much is the device and software
@@rightwingtrashrus274 mechaprog.com