Aftermarket controller on UberScoot 36v 1000w scooter

Поділитися
Вставка
  • Опубліковано 5 лис 2024

КОМЕНТАРІ • 44

  • @clarkie391
    @clarkie391 Рік тому +1

    Change plugs over use block connectors

  • @loyaltyovermoney5942
    @loyaltyovermoney5942 3 роки тому +2

    Same happen to mine got wet really bad from me leaving it out in rain. N it comes on but don't respond at all on throttle) EDIT: scooter working again it was a my speed controller I change n now it works got rid of 40 pound lead acid battery for a 11 pound 48v20h lithium I also install a gps speedometer and a volt meter now I keep my scooter indoors

    • @BrentTheGent1
      @BrentTheGent1 3 роки тому

      Hey,, what kind of run time do you get with that and did you have to swap your ESC for a brushless lithium one?

    • @loyaltyovermoney5942
      @loyaltyovermoney5942 2 роки тому +2

      @@BrentTheGent1 to upgrade to lithium u don’t u don’t have change esc but as of today I change 1000w brush motor for a 2000w brushless and it came with a 2000w esc I also added 3 speed switch to the controller before my scooter was only going 18 mph barley 20 now I can hit 30 n I’m 240 In fact when I ride my scooter on low settings now it faster then the origina I don’t even use high speed much also when I put lithium I also added a voltage meter more accurate I never had the scooter die on me fully my farthest I went was bout 4 miles but always make it back home with half battery

    • @BrentTheGent1
      @BrentTheGent1 2 роки тому +2

      @@loyaltyovermoney5942 Good stuff.
      I use mine as I have mobility problems and cant cycle so I was just out at the park with an old mate on his Mountain bike.
      The top speed of 25 mph is more than fast enough for me as I only go slow on the pavement as I cant be charred about or I end up in a world of hurt but if I just take it easy I can use it now and then.
      I think i may get the hill climbing kit as i dont need to top end and i lost many stones in weight since i bust my back up bad... so my 1000 watt Chaos 48 volt gets me up hills not bad.
      I just wished we had better weather here in NE Scotland. ✌🏼

    • @SheikhN-bible-syndrome
      @SheikhN-bible-syndrome 2 роки тому

      @@BrentTheGent1 where do you get the hill climbing kit ?

  • @ronniemay1397
    @ronniemay1397 Рік тому

    Hi when you took off the new connectors on the new controller was it a case of just pulling?

    • @gbsadventures3710
      @gbsadventures3710  Рік тому

      No, there are latches that you need to release. Use a small flat screwdriver, tiny one. One that a jeweler would use.

  • @rigodelgado1429
    @rigodelgado1429 3 роки тому +2

    What is the colors are different from the speed controller.

    • @loyaltyovermoney5942
      @loyaltyovermoney5942 3 роки тому +3

      Not that big of a deal just figure what's negative n positive even if its wrong trust me u will know for example if u connect key switch but the scooter turns on with out key that mean u have to switch the negative n positive wire same with lights etc n motor if u connect motor opposite wires it will turn backwards its like a puzzle just don't plug the battery wrong lol

    • @gbsadventures3710
      @gbsadventures3710  3 роки тому +1

      On mine, the only plugs I had to modify were the battery plug and the motor plug. All the others worked as shipped. The wire colors were of no consequence.

  • @charlesosterday5574
    @charlesosterday5574 4 місяці тому +1

    Why not this cut all connectors off and solder the wires together instead of using connectors it's a better connection anyways!

    • @gbsadventures3710
      @gbsadventures3710  4 місяці тому

      Soldering is a dying talent, since Heath kit went out of business.

  • @Cabinetselmi
    @Cabinetselmi 3 роки тому +1

    Salut
    Le 2ème vitesse ne fonctionne pas avec
    mon nouveau contrôleur
    = j'ai un seul vitesse.
    Où est le problème svp ?

  • @TheChristianTaoist
    @TheChristianTaoist 3 роки тому +1

    This was like how my life goes. Dude had me rolling!

  • @josiahrussell5
    @josiahrussell5 Рік тому

    Anybody know how to disconnect the speed limiter on these scooters. I had one and wanna try it

    • @gbsadventures3710
      @gbsadventures3710  Рік тому +1

      I am not an expert, but without the controller you will discharge the batteries extremely fast. Thus less distance. If sacrificing some power isn't a concern, you can change the sprocket size. Decrease the tire sprocket will increase speed.

  • @god-likesystems985
    @god-likesystems985 2 роки тому

    Hi, do you happen to know the capacitors size on the original UberScoot controller?

  • @paulbell2065
    @paulbell2065 3 роки тому

    Which cable do u cut to unrestricted speed thanks paul

  • @anio6865
    @anio6865 2 роки тому

    What is the name of those plastic connectors ?

    • @tylerbriggs7658
      @tylerbriggs7658 2 роки тому

      Did you manage to find them?

    • @gbsadventures3710
      @gbsadventures3710  2 роки тому

      The connectors I used came with the scooter or controller. So I dont have a source for them.

  • @TheChristianTaoist
    @TheChristianTaoist 3 роки тому

    Derailer would be for an e-bike. Just ignore it.

    • @gbsadventures3710
      @gbsadventures3710  3 роки тому

      On mine, the derailleur was needed, it went to the twist throttle on the right handle.

    • @TheChristianTaoist
      @TheChristianTaoist 3 роки тому

      @@gbsadventures3710 Interesting. Thanks for sharing that. It just goes to show that there is no set standard and there is plenty of room for variation within the system. Ugh.

    • @eggroll1up918
      @eggroll1up918 2 роки тому +1

      Chinese translate the throttle as the derailer.

  • @ryanw6423
    @ryanw6423 3 роки тому

    Brushed or brushless

    • @gbsadventures3710
      @gbsadventures3710  3 роки тому

      I believe it was brushless. I have since upgraded to the mototech chaos 2000w 60v

    • @eggroll1up918
      @eggroll1up918 2 роки тому

      Brushed. The way you can tell is brushed motors have two wires that go to motor. Brushless will always have 3 wires to the motor and sometimes 5 small wires for 3 hall sensors and + -for hall sensors. .

  • @tylerbriggs7658
    @tylerbriggs7658 2 роки тому

    Can I have the link for this?

    • @gbsadventures3710
      @gbsadventures3710  2 роки тому

      This was an old video. Not sure that controller is still available.

  • @connectionlost1063
    @connectionlost1063 3 роки тому

    What does the sport plug do

    • @gbsadventures3710
      @gbsadventures3710  3 роки тому +1

      The sport plug is for the economy switch. It is usually a red push button switch that allows you to change from full power, max speed, to low power, max distance.

    • @eggroll1up918
      @eggroll1up918 2 роки тому +1

      I've had several controllers with a sport plug, and I've never had one do anything different. As far as I could tell.

    • @connectionlost1063
      @connectionlost1063 2 роки тому +1

      @@eggroll1up918 it’s very weird that you chose to comment on this at this time as I haven’t used my controller since around the time I originally posted that but used it the other day and was trying to remember if shorting it put it in fast or economy mode, very strange lol

    • @connectionlost1063
      @connectionlost1063 2 роки тому

      @@Pete-yr9mt having this switch loop closed will slow the vehicle and use less power, open is the fast setting sadly

  • @mahinuddinkhan1110
    @mahinuddinkhan1110 2 роки тому

    Nic sir you are geats iam want you helf me ?am wating ...tnxs you

    • @gbsadventures3710
      @gbsadventures3710  2 роки тому

      Not sure how i can help. I no longer own this scooter.

    • @mahinuddinkhan1110
      @mahinuddinkhan1110 2 роки тому

      @@gbsadventures3710
      Tnxs sir all controller waring ditails pdf file gmail sent box tnxs you i am wating traning