Розмір відео: 1280 X 720853 X 480640 X 360
Показувати елементи керування програвачем
Автоматичне відтворення
Автоповтор
I think you need to make the last couple if dies little different to allow for the lower flange to pass easily
Do not be a square head wizard.Be a creative head artist.
where this component used
Sir mere ko Daai Ban wani h
El avance de la tira resulta exacto con alimentador
thank you a lot..
no soy un diseñador experto, disculpa la duda, como haces para que al avanzar el material la lamina no choque con el siguiente bloque? entre el primer y segundo doblez de la pestaña
Afortunadamente el diseño se prestó para crear un plano inclinado, la fuerza de avance debe ser suficiente para deslizar la tira por ese plano.
Future for Mechanical Engineer?
Totally
Nice
👌👌👌👌👌
Excuse me, this is software so it specializes in die design right?
Mechanical design in general.It can be usted in diferent kind of projects.See my youtube channel videos.
hello, can you explain to me why you left the idle station after holes piercing? thanks in advance
Hi, Just for safe and design freedom they are too close the punch and bending
which software use for it
KEYCREATOR 3D Direct Design.Try it. : info.kubotek3d.com/keycreator-student-version-free-software?111
I think you need to make the last couple if dies little different to allow for the lower flange to pass easily
Do not be a square head wizard.
Be a creative head artist.
where this component used
Sir mere ko Daai Ban wani h
El avance de la tira resulta exacto con alimentador
thank you a lot..
no soy un diseñador experto, disculpa la duda, como haces para que al avanzar el material la lamina no choque con el siguiente bloque? entre el primer y segundo doblez de la pestaña
Afortunadamente el diseño se prestó para crear un plano inclinado, la fuerza de avance debe ser suficiente para deslizar la tira por ese plano.
Future for Mechanical Engineer?
Totally
Nice
👌👌👌👌👌
Excuse me, this is software so it specializes in die design right?
Mechanical design in general.
It can be usted in diferent kind of projects.
See my youtube channel videos.
hello, can you explain to me why you left the idle station after holes piercing? thanks in advance
Hi, Just for safe and design freedom they are too close the punch and bending
which software use for it
KEYCREATOR 3D Direct Design.
Try it. : info.kubotek3d.com/keycreator-student-version-free-software?111