5 Symptoms Of A Bad Purge Valve
Вставка
- Опубліковано 1 лип 2024
- In this video we'll talk about the purge valve and what the symptoms of a bad purge valve look like.
If you'd like more information you can read our guide: vehiclefreak.com/5-symptoms-o...
We cover the following questions and topics:
symptoms of a bad purge valve
can bad purge valve cause stalling
purge valve stuck closed symptoms
signs of a bad purge valve
what happens when a purge valve goes bad
how to tell if evap purge valve is bad
what is a purge valve in a car
purge valve solenoid symptoms
canister purge valve symptoms
We hope this video was helpful!
DISCLAIMER: Any information we provide in this video is intended as education. Vehicle Freak and it's operators shall not be
liable under any circumstances in case of any injury, damage, or any other accident that may occur. By watching this video, you agree to these terms. Vehicle Freak and its operators may earn from qualifying purchases as an Amazon associate. - Авто та транспорт
I paid $20 for an aftermarket valve from Amazon and it took me less than 5 minutes to change for my Chevy Equinox. I have noticed a huge difference in my cars Idling, power and gas mileage.
This is the best description I've seen among all the videos. Thank you!
I just replaced my purge valve on my 2003 Buick PA... It tested good in regards to holding a vacuum, it was an aftermarket part. I was throwing an evap leak code, so I replaced with an ACDelco OEM valve, code gone. Spend the extra money and get the OEM part.
It also depends on the age of the vehicle also I have a 95 Plymouth Grand Voyager 3.3 6 cylinder right now my evap canister is disconnected I have no issues with fuel economy fuel vapors or fuel tank issues nothing in fact my vehicle runs even better and gotten better on gas mileage
Thank you very much for these useful tips. This video gave me very important information about the PCV valve.
I had 1994 that I removed all the evap parts. Put a regular vent on the hose from the tank, and plugged all the vacuum lines. OBD 1 so it didn't check see if it was working. I think 1996 & up OBD II the ECU checks to see if it is working.
Interesting, I’ll check it out
evap codes can be many other things beside purge valve and can add up to alot of$. helpful video.✓
Or it could be simple as needing a new gas cap
Good video, easy to follow, but a lot of these symptoms are very vague and can be caused by a lot of other issues, as well.
Labor cost of that amount no longer exist. 😂
So on my van I never have problems with the smell of gas, but if the day goes up to about 92 degrees and when I run the back AC which puts a further drag on the engine, after about an hour it smells horrendous of vaporized fuel. My theory is that when the ambient temp in the engine rizes high enough the purge valve stays open allowing for the gas to leak out. THis condition is not often so I was wondering if I could override the value command from the ECU and make an external switch that will force it closed for a little while until I can get on a freeway to allow the engine to cool rather than the city stop and go. All parts have been replaced but still and issue. Any ideas around that duck tape idea?
Bad injectors and fuel pressure regulator do the same thing too
A bad purge valve may cause bloating, upset stomach, and diarrhea…
Why every 10,000 miles i put a bottle of Pepto Bismol in my gas tank !! 😄
what about constipation...
And sometimes death!
Lmao😂
😂😂😂😂
Thanks boss
Before trying all this try an alternative.......every time you park rev it up to 5000 for five seconds. It worked for me.
If its open there is no engine light.. is normal it tiks hard ad Idle?
Please tell us about anti-pollution fault ?
In my golf GTI 92 the valve not stay open or close, She ticking quickly, and work principaly at idle, its normal? I have disconnect the connector because the engine working a bit bad🤔
Can it vaise it to blow white smoke from the exhaust
Mine ,when truck running take the hose off want suck air at all even waiting 5 to 10 minutes running. Can you help me. Thanks.
My 2.4 engine is idling rough. The code says emission system small vacuum leak. When I completely cover the vacuum line going to the evap system, the rough idle does not go away. There is no change. Any ideas?
No not really.. First, you show a carbureted engine and purge system. Not to many of those from the factory anymore. ALL the symptoms you mention MAY occur on a carb vehicle with an evap system but not on a fuel injected engine even though you try to relate it to a computer (EEC) controlled engine. The sole purpose of the "evaporative emissions system' is to prevent EVAPORATING fuel vapors from leaving the vehicle and entering the atmosphere. Hence the name. The vapors from the fuel tank are captured in the charcoal canister and then "purged" back into the engine to be burned at certain times during in the combustion process. Fuel tank venting is usually run through the charcoal canister so you might get a gas smell in your garage if the purge valve is inop and likely the computer would give a fault code. If the canister is damaged or plugged you may get fuel delivery problems from not allowing venting into the tank, but that's not the purge valve's issue. Fuel economy might suffer if a vacuum line in the evap system leaks allowing extra air in as would any uncontrolled vacuum leak. Again. not the purge valve. Even if the system does not use a canister to hold vapors, you make this sound way worse than it is, and you repeat yourself to make it sound that way.
Does this cause p0448?
bro said all the things like 1000times😆
😂😂 nbs
Im glad my purge valve was only 25 dollars
The getting fuel and hard start after is the surefire sign it's bad
hi, i just saw the video,
does the purge valve affect the RPM to go up to be high, or sometimes on the other hand the RPM goes down?.
Could be a bad idle air control valve or IAC
Will a faulty Canister Purge Valve cause the vehicle to go into limp mode?
Its vacuum not pressure right? Right!
Can a bad charcoal cannister can also cause clogging for line to purge valve? I am having hard starts and stalling and mechanic said my purge value is working as it should but clogging of lines because of bad cannister most likely culprit. Would you agree?
Your mechanic should've been able to answer that question with a simple test - pull the bottom (closest to the ground) hose off the charcoal canister. If gas leaks out, your canister is full and needs replacement.
Can u clean a purge valve ?
question please answer. can a purge valve or evap issue cause back fire? my car started some tail pipe backfire after i had exhaust work done,, could that have loosened a hose or connecton with evap system. crazy question i know... but i need to figure this out. thx in advance also.
yes it will backfire a bit especially when accelerating for a while then releasing off the gas pedal
@@xdkoobie6628 i appreciate reply.
You forgot, 'an incredible racket', you heard mine in the car.
Was probably on its way out.
I just changed one in my 2012 impala because it was hard to start
did it fix the issue?
will a stuck open purge valve cause hard to put gas in the tank like the pump keeps kicking off
no. I think that's your canister vent solenoid being stuck closed.
What's the difference between a purge valve and a EGR valve???
A purge valve is needed to clear too much gas vapour in a maybe a half tank of gas in hot summer. The EGR valve work to eliminate the Knox in the exhaust system by cooling the exhaust gases. The EGR will often when you drive on highway, because it doesn't disturb the engine running and this highway speed produce more Knox, that is a gas causing damage to atmosphere.
I have an issue with the car seeming to want to stall and but usually it keeps going. It actually did go out once with the lights coming on a couple of weeks ago. Three mechanics can't figure out what is wrong. No codes come up. We did have the canister and canister close valve replaced because we couldn't pump gas properly. So now we have this new issue and I'm not sure if it is connected to the same parts. Is the purge valve the same and canister close valve? This has been so stressful because I don't know what is going on. It seemed random but I am pretty sure now that it happens after I pump gas. Not right away but the next time I use the car. Any thoughts?
Don't expect this guy who put the video together to answer. He's just reading the repair manual, and put out this crappy video..
PCV Diaphragm fixed this issue on my VW Passat, Purge Valve was needed as well but for the first bit.
"Purge valve" is used constantly in this video, but I think it is often referring to the canister vent solenoid and stated differently. There is a purge solenoid located near the engine top and near the throttle body, so I am a little confused as to what this person is always referring to. Most Vent Solenoids are located near the charcoal or vapor canister and yes, it does perform a purge function, however, most refer to it as a vent.
I think he is speaking about the one in the eng compartment
How dare you the estimate of labor price!!!! On your video, for people that doesn’t work on cars will thing is easy but most of the time isn’t easy to find out what’s going on with the evap codes
Talk about driving your point home
Your voice sounds like Dean Cain !
I got my purge valve replaced today because the engine light came up, but I have noticed that my car is not going more than 3000 Rev, does anybody knows the cause of this? I have a 2022 ford mustang
It’s probably just a faulty part I had to replace mine again after I replaced it the first time because it was faulty. Every time I would get gas it would run roughly when idling like it wanted to cut off. Also if you are getting gas don’t put any extra fuel in the tank once the pump stops. That is also bad for the fuel system.
@@davidallen8348 I've just replaced mine for the same reason, seems to be a common point of failure for this model from what I've found online
👌🏼👍🏽
All my lights are on
Every single thing said on this video is absolutely incorrect. Please do not mislead people on what the purge valve does before making videos like this. Just my humble opinion.
Symptoms of a bad purge valve repeating the same thing over and over again.
Amazon 20 bucks
I’m confused on one thing, how can the purge valve expel all the fuel and air from the engine after being shut off, if the purge valve is AT the air INTAKE.
Once the engine is off, there is nothing coming out from the exhaust because the intake and exhaust valves are alternatively closed, and the pistons are stopped in different position.
So if the valve is defective and stock open, you’ll just have a hard time starting the car again, that’s all
He's talking utter rubbish. Clueless.
you didn't tell nothing
When I'm at the gas pump it shuts off literally after every few seconds making it take 10 minutes to fill my tank ...can it be the purge valve?
I would like to know the answer to this. My truck has the same problem at all the gas pump.
Yes it definitely can be. Had that same problem with my 04 Ranger for over a year, changed the purge valve about 2 months ago and haven't had that problem since.
yes
@@brandoncharge1516 did you have a code ? ...i suspect mine is bad , but will test when my wife gets home . gas pistol shuts of ....it dosent accelerate as normal . volvo s80 t6
@@lassenielsen4340 Yeah the truck had a P0456 "small evap leak" code.
"A faulty purge valve can cause serious damage to your engine," said no engineer or mechanic ever. Come to think of it, almost no engineer would agree with much of anything in this video
Ozzammaz ZOOLOO VOODOO
I used to be a purge valve.
Lol. It reduces vapor in the tank. Has nothing to do with vapor in the engine dude. Lol
very confusing video. I really don't think you have a clue what you are talking about. (Clears out any leftover fuel from the engine?) a purge valve draws fuel vapors from the charcoal canister. Over heating? I'd like to see that. So stuck shut... won't push fuel vapors back into the engine instead they will run straight out of the exhaust blah blah..... get real, vacuum won't pull (air pressure pushing) fuel vapors from the tank, there's no vapors or fuel getting out the exhaust. I also doubt any shop would only charge $53 to change the purge valve, they would do diagnostics first even if you told them what you thought was wrong. "Oh my car is heating, steam everywhere, put on a purge valve", then you're mad because nothing was wrong with the valve, the thermostat was stuck.
easy by pass
junk
Respectfully : you are talking nonsense. "Clueless" doesn't even start to describe. Must've been some work in order to get close to everything wrong.
I don’t trust advice from someone who can’t spell hard