How To Hand Cut Half-Blind Dovetails

Dovetails, the classic drawer joint. Creating half-blind dovetails leaves you with a rock-solid joint that looks beautiful. Here, Logan shows us how he creates this joint using hand tools.
Subscribe to Woodsmith to receive tips, plans, projects, and techniques both in print, and in video. It’s all at www.woodsmith.com.
Follow us at / woodsmithmagazine
www.woodsmith.com
#woodworking #woodsmith #woodsmithshop #dovetails #diy #dovetaildrawers #woodsmithmagazine

[@jameskarwacki5802]

Thank You Sir. I have a Leigh DR3 Jig, but wanted to go a step beyond with hand cut.

[@bigsparky65]

Excellent video, nice to see handcrafted wood work again. It seems to a lost art.

[@garypopa6384]

A skew chisel is a valuable tool for cutting half-blind dovetails which can reach deep into the corners. If you don't have a skew chisel a small sharp pen knife will work almost as well. I don't have a magnetic dovetail jig, think $60 is just too much. Instead have used a hard maple scrap block customed cut to the desired angle. A Moxon vise with task lighting are also good tools. Watch Rob Cosman's videos.

[@perrych2012]

The cleaning up of the corners (at about 14' 45") made me wince to see his hands holding the wood behind the line of travel of the chisel. I tell my children to never have the chisel travelling towards your hand - put it in a vise.

[@dpmeyer4867]

cool, I like the idea of having your strop right there to 'tune up' the chisel.

[@stevenhealy2554]

If you don’t put an edge on the card scraper the joint is less likely to split during assembly. It does require that you make a few incremental passes when clearing out the rest of the kerf.

[@gregshoopman9170]

Thanks several tips I can use

[@FearsomeWarrior]

For myself I’d call the ‘hammering the card scraper’ trick useful but only as much as I think I can get away with it. I wouldn’t try to get to the full depth at all and would only get a little deeper then the saw cut. I might clear it with a knife a few times too. I think it’d depend completely on the feel I get. Obviously you don’t hammer it even harder when the wood resists.

[@elabelcreacionesenmadera2687]

hola, soy oscar, de santiago , explicas muy bien pero cuando lo llevas a la practica veo que te falta, sigue practicando ya mejoraras, a mi me lleva años mejorar y todavia no lo logro, tengo 60 años ya , debes insistir. saludos desde santiago.

[@tomterrific8574]

What do you mean when you say that you are "undercutting"?

[@WoodsmithShowandmagazine]

Tom, when I undercut, I'm cutting the surface not at 90 degrees, but 92 degrees. It gives the joint a little room to go together better.

[@leyderness3553]

Mine comes out looking like you used a hatchet!

[@jeanpierreragequit1726]

25:39 : very nice job... but when ur "queues d'arrondes" are to wide, its a drama.