A good video but made a mountain out of a molehill for removal imo and I don’t get the plastic fuse reference near the beginning looks like a retaining clip to stop the electrical plug coming off the throttle body too easy , maybe I’m wrong , but seriously I came here looking for some more info of wether I can adjust the flap in any way I took mine off it was dirty far beyond what this one is like, it looks like now even though spotless the flap doesn’t close fully there is still a 1-2 mm gap and I can push it back closed with my thumb and it springs back out again is this normal or a fault ? Very detailed video anyway thanks for uploading
I also think that's normal. Later when install it ECU perform fine tuning of the flap position on the base of exhaust gasses (readings from oxygen sensors). Here I also replaced ECU (another video) and instructions says that this cleaning is recommended because of that ECU tuning. Main object is to remove dirt from throttle body which can be problem for these operations.
@Jovica Mitrev Da, ali nemaš kablove za svijećice. Imaš samo blok bobine koju izravno staviš na svijećice (bez kablova). Sam blok bobine je izravno spojen na kompjuter (ECU). ua-cam.com/video/YbkuCp--d3g/v-deo.html
Where is the throttle body position sensor?
I have Vauxhall (Opel) Astra 1.6 16v petrol 2003.
Is it the same throttle body as this One?
Please Answer?
Probably yes. That should be also one variation of Z16 engine.
opel.7zap.com/en/car/t98/g/0/48-1/
opel.7zap.com/en/car/t98/g/0/48-2/
Please please who is open cabreta?
A good video but made a mountain out of a molehill for removal imo and I don’t get the plastic fuse reference near the beginning looks like a retaining clip to stop the electrical plug coming off the throttle body too easy , maybe I’m wrong , but seriously I came here looking for some more info of wether I can adjust the flap in any way I took mine off it was dirty far beyond what this one is like, it looks like now even though spotless the flap doesn’t close fully there is still a 1-2 mm gap and I can push it back closed with my thumb and it springs back out again is this normal or a fault ? Very detailed video anyway thanks for uploading
I think it’s normal, every throttle body I’ve seen stays open a tiny amount.
I also think that's normal. Later when install it ECU perform fine tuning of the flap position on the base of exhaust gasses (readings from oxygen sensors). Here I also replaced ECU (another video) and instructions says that this cleaning is recommended because of that ECU tuning. Main object is to remove dirt from throttle body which can be problem for these operations.
Is it safe to open the throttle by hand when cleaning?
Yes, but you need to be very careful with fingers...spring is pretty strong.
Дали е можно моторот да не работи мирно доколку е прљава клапната, фала многу поззз
Moguće je, ali može biti problem i sa sistemom paljenja kao što su svijećice i bobina.
@@fire2hr svekici se menjati novi stavani,mozda treba da smenam kablite za svekici,ok pred se,Fala na sovetot :)
@Jovica Mitrev Da, ali nemaš kablove za svijećice. Imaš samo blok bobine koju izravno staviš na svijećice (bez kablova). Sam blok bobine je izravno spojen na kompjuter (ECU).
ua-cam.com/video/YbkuCp--d3g/v-deo.html
Pozdrav zanima me dali mogu u obicnu vectru b ugradit digitalnu konzolu?
Žao mi je, ne bih znao.
10:38 Its so hard to remove that connector on my Zafira, it was starting to piss me off
Please please who is open cabreta?