Hey Bro Nice drift run! I was wondering what wheels you used on your rear during this vid? I was looking online what narrow wheels would fit the 370. Thanks and keep up the great content :)
@@AalinGelee Not 100% sure if I remember, I think the offset is a bit small, like ET25 on 8J wheel, so I'm running spacers as well. Ideally you want at least ET15.
@@AalinGelee Any aftermarket oil pressure will do. You need an oil pressure that's 52mm in diameter, an oil pressure sensor, and a T connector. You will remove the factory oil pressure sensor, insert a T connector to its location, and then you can have the factory sensor back, as well as add another pressure sensor for the gauge. You then run the wires to the pressure gauge. This is probably the trickiest part, if you want it done nicely, as you will need to run the wires through the factory loom that goes through the tight rubber connector between the door and the car. It's doable, but it takes quite a bit of effort....but then it's done properly and looks factory.
Haha blasting eurobeat while drifting in a mountain road in a japaneese car, classic.
That's what it's all about!
Best car ever made right there
Awesome skills🙌
Odlično 👌👌🎖
hope charlie & angel supported sarah n tuned during pride month!
Nice z love my z
Eurobeat intensive😅
Is that John Wick driving?😳
don't tell anyone!
@@rideepicdriveepic Ok🤫
Hey Bro
Nice drift run!
I was wondering what wheels you used on your rear during this vid?
I was looking online what narrow wheels would fit the 370.
Thanks and keep up the great content :)
Wheels are 18", 245-45 tyres on, with spacers, but they are still kinda inside the wheel well.
@@rideepicdriveepic thx for getting back
Do you know the offset?
@@rideepicdriveepic also, where did you get the oil pressure gauge in the door vent?
@@AalinGelee Not 100% sure if I remember, I think the offset is a bit small, like ET25 on 8J wheel, so I'm running spacers as well. Ideally you want at least ET15.
@@AalinGelee Any aftermarket oil pressure will do. You need an oil pressure that's 52mm in diameter, an oil pressure sensor, and a T connector. You will remove the factory oil pressure sensor, insert a T connector to its location, and then you can have the factory sensor back, as well as add another pressure sensor for the gauge. You then run the wires to the pressure gauge. This is probably the trickiest part, if you want it done nicely, as you will need to run the wires through the factory loom that goes through the tight rubber connector between the door and the car. It's doable, but it takes quite a bit of effort....but then it's done properly and looks factory.
Hvala ti da si dal moj video noter
Hvala tebi za posnetek!
@@rideepicdriveepic ja ni problema!
Everything stock ? If modded....what are the mods ?
OS Giken LSD with a shorter FD (4.08). Smaller wheels in the back (245-45-18). Other mods don't contribute to the driving.