ESCAPE DIY FOG LIGHT INSTALL! Tying up loose ends

Поділитися
Вставка
  • Опубліковано 18 лис 2024

КОМЕНТАРІ • 9

  • @teaganostrow4421
    @teaganostrow4421 2 роки тому +2

    You're driving your car with a bucket and then you're getting the seat great video

  • @iSteven180
    @iSteven180 2 роки тому

    You should have wired it to a switched power source in case you accidentally left them on when the key is out. You could drain your battery. Though great to know about the headlight switch interchange. Ford did the same thing with cruise control in the 2nd gen focus where it was a new steering wheel plug in and play setup.

    • @BlakesCars2
      @BlakesCars2  2 роки тому +1

      I actually didn’t mention, I added an inline fuse to the ignition so I have a safety just in case. I’ve done that in the past to vehicles and have regretted it haha

  • @BradimusMaximus78
    @BradimusMaximus78 2 роки тому +1

    Man I would love to drive a manual escape!

    • @Dennis_Heaton
      @Dennis_Heaton Рік тому +1

      That's what my wife has, and she doesn't want a new one unless it's manual!

    • @BradimusMaximus78
      @BradimusMaximus78 Рік тому

      @@Dennis_Heaton I don’t blame her!

  • @alvaromendes4278
    @alvaromendes4278 Рік тому

    Many thanks!

  • @The_Jonstigator
    @The_Jonstigator Рік тому

    Bummer you can't wire those fog lamps through the headlight switch. Were there any blank pins in the connector? Perhaps a connector for an XLT? Were you able to find a wiring diagram? I will be doing the same thing to my 2012 XLS soon plus blacking out my front end. It would be great to know all the dead ends you encountered so I can avoid them. Thanks for a great video! Very informative.

  • @mitchell7568
    @mitchell7568 2 роки тому

    Nice video :)