Sole Treadmills - LS Error Calibration

How to Calibrate All Sole Treadmills when Console displays LS Error

[@triciaforsting3648]

OMG 😳 I can’t believe it but I think it worked
I recalibrated my Sole F60 thanks to your detailed instructions. My treadmill kept showing LS1 error code. I thought treadmill was on its way to the side of the road

[@davishilton8926]

THANKS!! IT WORKED!!
Had incline error and it fixed it.

[@lawrenceramjass8074]

Thanks alot was having problem with my incline blessed

[@ATTIBUTT]

Thank you for sharing I can use my machine again 😀

[@krakengrip]

Thanks so much! I thought my kids dumped his water into the unit to get out of using it.

[@remaxlul546]

Worked

[@djlovenlive3920]

Wondering if you could advise... My Fuel 63 treadmill belt was slipping as I ran, so I disconnected the machine and adjusted the belt as instructed in the manual... However when I was about 40 minutes into my run the treadmill just started speeding up on its own to maximum velocity and only stopped when I removed the safety key... Since then every time I switch the treadmill on I just goes straight to full velocity without me touching any buttons, then cuts out and it just repeats the same sequence (Speeding up and cutting of and so on) until I disconnect the key!!! Absolutely baffling!!! Can you help ??

[@jesusolivas3831]

But what about the older models like the 2007 s77 I can't remove the safty key without shutting of the treadmill

[@ninjaguitarist5656]

This doesn't work for me, I have the F65 model and It is not working, diferent controls and setup

[@treadmillhospital]

I have the new motor controller and speed sensor from SOLE.

[@anangrysack]

What if you get is error while calibrating? That's what's happening to me

[@jasonyoung880]

I found metal fragments probably fom the garage floor on the wheel magnets where the sensor rides,removed the metal and did a calibration and works great

[@whity-ei3tf]

I have solved this problem near the power key There is a red dot written on it 10A pull out and open the plastic and clean by sandpaper two wires points inside

[@spidemine1285]

I'm going to try this thanks, but I do have a question after it's done it should work fine right?

[@spidemine1285]

Boyles Fitness Equipment ok thank you for the help😊

[@treadmillhospital]

我有SOLE的新电机控制器和速度传感器。

[@krakengrip]

Well, I spoke too soon. My unit shows the software version but never enters calibration.

[@stanbecks1097]

hi why did you enter 2.36 roller size?

[@kristenshumaker649]

I am trying to change fuse but every time I turn it on it blows the fuse again? Is something else wrong?

[@robertthong6823]

I still can’t work

[@professorbrown2191]

Damn, Still getting ls1 low speed

[@Pakistaniinameric]

Same

[@Stychy]

u suk