Wire clamp tool, simple and easy. Groovy Baby de Audionautix está sujeta a una licencia de Creative Commons Attribution (creativecommon...) Artista: audionautix.com/
This is a very good design. Simple and effective. What I learned from this video is something I could never imagine...how to make the loops. When I used my own homemade clamp-tite tool, I wasted a lot of wire as I had trouble figure out how much is needed to complete the loops. This video depicts how to make the initial loops, then doubled up and slipped them over the host object. Brilliant idea. Thank you very much.
by far the best explained video i had made one a month ago and couldnt figure out how to make the clamp i thought i screwed up till this video thank you!!
The initial setup of the wire is a prussic knot - save yourself a few minutes: bend the wire in the middle, hold bend close to the hose on top, bring both wires ends under and through the bend twice then pull up, dress the initial setup - ready to go.
By far the best of the 14 videos I've watched on wire clamps! 🤩 👍
By far the most efficient tool design for this purpose. Excellent job. TY
This is a very good design. Simple and effective. What I learned from this video is something I could never imagine...how to make the loops. When I used my own homemade clamp-tite tool, I wasted a lot of wire as I had trouble figure out how much is needed to complete the loops. This video depicts how to make the initial loops, then doubled up and slipped them over the host object. Brilliant idea. Thank you very much.
Thank you very much for your comment.
by far the best explained video i had made one a month ago and couldnt figure out how to make the clamp i thought i screwed up till this video thank you!!
Thank you.
JS, [ "How To Make The Clamp." ] You genius! Thank you for making this video so much. Tim. ( - :
Thank you for watching this video.
Very cool, I liked your video.
Cool. But would be nice to have leveraging tool inclooded
yes, thinking later, you have to leave the iron handle a little longer.
Cut the tool too short, so dificult to work with it.
The initial setup of the wire is a prussic knot - save yourself a few minutes: bend the wire in the middle, hold bend close to the hose on top, bring both wires ends under and through the bend twice then pull up, dress the initial setup - ready to go.
If the wire is very stiff or hard it is very difficult to do so.
👍👏👏👏👏👏👍
🇪🇨👍🏻
Lo tienes en español, también. Un saludo.
ua-cam.com/video/SNBtOjOyZT4/v-deo.html