HOW TO REPLACE EXTERIOR DOOR HANDLE MECHANISM ON FORD FOCUS MK3

Поділитися
Вставка
  • Опубліковано 19 гру 2024

КОМЕНТАРІ • 8

  • @WorldMechanics
    @WorldMechanics  5 років тому +1

    ⛐ Check out our Garage to see what tools we use and recommend:
    www.amazon.com/shop/worldmechanics
    ⛐ Subscribe and hit the notification bell by the subscribe button for new videos: ua-cam.com/channels/J9xpq0qUZevSEdBSFqO2ow.html
    ⛐ Our GoFundme Page: www.gofundme.com/auto-repair-guys

    • @grazianolaudisio3644
      @grazianolaudisio3644 4 роки тому

      Thank you for explaining.
      Thanks to your video I was able to replace my right front passenger door and transfer all components with it!👍🏻

  • @pheirphon4680
    @pheirphon4680 Місяць тому

    There are 2 torn screw at the rear door panel.

  • @abrahanguillen1903
    @abrahanguillen1903 4 роки тому

    I replace my rear right door latch and now the switch door lock unlokc button is not working when you press to open or lock automatically all 4 doors lock and unlock immediately because the small light on the switch button is not working since I change that latch
    Can you help what to do ?

    • @grazianolaudisio3644
      @grazianolaudisio3644 4 роки тому

      You have tried to disconnect the battery? I had the same issue, after disconnecting the battery for 30 min it was working again.

    • @abrahanguillen1903
      @abrahanguillen1903 4 роки тому +1

      @@grazianolaudisio3644 I have resolved the issue friend thanks

    • @grazianolaudisio3644
      @grazianolaudisio3644 4 роки тому

      @@abrahanguillen1903 Good to hear!

    • @abrahanguillen1903
      @abrahanguillen1903 4 роки тому +1

      @@grazianolaudisio3644 actually was not disconnected the battery the problem in my case was that I replaced the door latch for one generic not original so that was the problem but one day I spend all the day in that issue until I found out that the generic door latch has only 4 pins instead the original one has 5 or 6 pins so I cut the middle thing wire so that was the issue now works perfectly