Розмір відео: 1280 X 720853 X 480640 X 360
Показувати елементи керування програвачем
Автоматичне відтворення
Автоповтор
Just be aware that the output of the signal generator has a DC component, so a blocking capacitor will be needed if it is used as a signal injector.
A great learning video, thanks.
@@colindigitaljames6619 🙋🙏🙏
Thank you for the information. I will be referencing your video again to learn to use mine.
Щиро дякую!
Спасибо брат
если нажать и удерживать в меню кнопку дисплей, то появится подменю, и там можно дабавить частоту на екран.
now that's cool
There's arbitrary waveform generator function on this? Your video thumbnail says so
Hi, there's a noise signal, like many signals at the same time,
Where is the output of the generator please?
@@josefmottl5729 Above the device, there are two connectors.
@@32davdi I understand! The 1kHz output intended for calibration is also the output of the generator.
@@josefmottl5729 it's output is from 0Hz to 5MHz ,
Can I use the current probe CC650?
Not tested yet these two together, but I think yes You can use CC650 clamp .
@@32davdi👍
Zeeweii dso3d12
Не могу понять как в Меню переключаться между окнами по вертикали.I can't figure out how to switch between windows vertically in Menu.
Hello Victor, Press [Shift ] then [ CurX ]. Or [ Cur Y ]. Then [ Shift ] Only , To switch the line.
Just be aware that the output of the signal generator has a DC component, so a blocking capacitor will be needed if it is used as a signal injector.
A great learning video, thanks.
@@colindigitaljames6619
🙋🙏🙏
Thank you for the information. I will be referencing your video again to learn to use mine.
Щиро дякую!
Спасибо брат
если нажать и удерживать в меню кнопку дисплей, то появится подменю, и там можно дабавить частоту на екран.
now that's cool
There's arbitrary waveform generator function on this? Your video thumbnail says so
Hi, there's a noise signal, like many signals at the same time,
Where is the output of the generator please?
@@josefmottl5729 Above the device, there are two connectors.
@@32davdi I understand! The 1kHz output intended for calibration is also the output of the generator.
@@josefmottl5729 it's output is from 0Hz to 5MHz ,
Can I use the current probe CC650?
Not tested yet these two
together, but I think yes
You can use CC650 clamp .
@@32davdi👍
Zeeweii dso3d12
Не могу понять как в Меню переключаться между окнами по вертикали.
I can't figure out how to switch between windows vertically in Menu.
Hello Victor,
Press [Shift ]
then [ CurX ]. Or [ Cur Y ].
Then [ Shift ]
Only ,
To switch the line
.