2) once the old motor is removed solder the new one in its place then re-assemble the drive unit, the bottom left gear goes spring down. this section can be fiddly to put back together but trackmaster has done us a huge favor with these very simple drive units. the switch should be put back in as a whole assembly and be sure to install it in the off position, once you have screwed the case back together time to test the drive unit with a battery. if all is well put it back in the locomotive
What a race! Poor Hiro, he may be very fast but age is catching him up to stay on the tracks :P Hope I can soon get some of those Tamiya Power Dash motors.
Hi well I took the drive unit out then unscrewed the casing and switch assembly, lay drive unit flat on its side so the switch area and screwholes are facing up, lift off the first section gently. You will see the motor and 3 gears, pull out the bottom left gear it has a spring attached, lift out the motor section of the case the motor will come out attached to the case. Slide the gear gently off the motor, slide the gear onto new motor. heat up the terminals on the old motor and remove it.
heres a suggestion if hank gets stuck on the hill why dont you just power up both him and his tender, his tender may be able to help him get up the hill
I remember when my dad did a AAA battery mod on my tomy Henry James and diesel and they went really fast the only one which still works is Henry because diesel and James stopped working a couple of years ago
People seem to use the couple as a drawbar bit it actually hits the back of the tender so thqts why it gets stuck. for hank and murdoch i personally buy a spares or repairs coupling of a tomy james , gordon or henry and use their coupling to shorten murdoch, emily, moll and hank's coupling. by the way where did you get that crane at 5:25 i haven't added that to the oayout. you should add an airport to your layout too. i've aded one to mine , just infront of the yrd
then there was trouble 9:44 hiro bump hank so hard he fell off the tracks hiro: WOAH ( crash bang ) with a bang and a clang he came off the bridge lucky no one was hurt and the bridge was not that high
Hi this is the new Trackmaster Hank which is loco powered but an older type tender (didn't have a new tender at the time of filming). This Hank is now my VR R class tribute custom
Tamiya power dash is the best motor to use on a normal battery. you should connect a battery to it before installing it to the train and let it run for a couple of hours it will increase in power and speed.
yes poor old Hiro, I'm loving these flat drive units and power dash is absolutely the motor I will be using from now on.
2) once the old motor is removed solder the new one in its place then re-assemble the drive unit, the bottom left gear goes spring down. this section can be fiddly to put back together but trackmaster has done us a huge favor with these very simple drive units. the switch should be put back in as a whole assembly and be sure to install it in the off position, once you have screwed the case back together time to test the drive unit with a battery. if all is well put it back in the locomotive
6:24
Hank gets stuck on the mountain
Nice work man! You're loving those motor mods.
What a race! Poor Hiro, he may be very fast but age is catching him up to stay on the tracks :P
Hope I can soon get some of those Tamiya Power Dash motors.
Now that's incredibly fast!! Great video as always :-)
Hi well I took the drive unit out then unscrewed the casing and switch assembly, lay drive unit flat on its side so the switch area and screwholes are facing up, lift off the first section gently. You will see the motor and 3 gears, pull out the bottom left gear it has a spring attached, lift out the motor section of the case the motor will come out attached to the case. Slide the gear gently off the motor, slide the gear onto new motor. heat up the terminals on the old motor and remove it.
heres a suggestion if hank gets stuck on the hill why dont you just power up both him and his tender, his tender may be able to help him get up the hill
I remember when my dad did a AAA battery mod on my tomy Henry James and diesel and they went really fast the only one which still works is Henry because diesel and James stopped working a couple of years ago
possibly in the future I will make a couple to see how it goes.
Thanks just like a big mainline engine should be! Are you listening up Trackmaster?? hehe
Hi got the crane at Target for $7.50 LOL yes I might try a loco coupling that you mentioned
Thanks its even funny to me when I watch it, poor Hiro
Ucwepn why hank is motorized but his tender is motorized also?
Jason the L.B.S.C E2 Class engine so he can go faster. That’s why.
People seem to use the couple as a drawbar bit it actually hits the back of the tender so thqts why it gets stuck. for hank and murdoch i personally buy a spares or repairs coupling of a tomy james , gordon or henry and use their coupling to shorten murdoch, emily, moll and hank's coupling. by the way where did you get that crane at 5:25 i haven't added that to the oayout. you should add an airport to your layout too. i've aded one to mine , just infront of the yrd
You should put those motors in Connor, catlin , Spenncer, and Gordon and have demalition derby with the for engines
Hi good suggestion but i worked out why he did it, the coupling is too short and inflexible and raised the drive wheels in the air
Have you done a video of those two with their motor swaps pulling freight and passenger cars?
At 9:45. Did hero fell off the track to the ground?
I think it is the coupling between Hank and his tender that's getting him stuck on the hill.
9:46
CRASH! BANG!
Ucwepn: OOOOOOOOOOOOOOOOOOHHH!!
then there was trouble 9:44
hiro bump hank so hard he fell off the tracks
hiro: WOAH ( crash bang )
with a bang and a clang he came off the bridge lucky no one was hurt and the bridge was not that high
9:46
R.I.P Hiro
2009 - 2020
He Fell Off The Bridge
Well at least he’s not dented
@@supermariofan1217 Oh, come on! It is just a joke really!
@@supermariofan1217Hiro is still alive!
ouch that must have hurt
What battery would you suggest with a plasma upgrade?
+juhs GA ENL nimh rechargeables, the higher the mah the better. Alkalines run out very fast
yes onto the concrete floor :( no obvious damage though
How’d you put it? I want to put it into Connor and Caitlyn, Flying Scotsman, Shooting Star, and Royal Spencer, and maybe Rg. Gordan and Reg. Spencer
Ucwepn which is better Lightdash motor or powerdash motor
hi yes thats him but the TWR version sadly
where dod you get it. i would like to put it on the layout sooner.
Hank gets stuck up the hill because his huge thingy at the front
still have to make that video its still in its packaging
Tardis at 6:16
Why does hank have that front? I thought his tender pushes him
Hi this is the new Trackmaster Hank which is loco powered but an older type tender (didn't have a new tender at the time of filming). This Hank is now my VR R class tribute custom
Ucwepn r4f00
Ziggy Craft its the 2013 version, loco powered
قققللبببببببببعص223لب322فف2ی22ب221111111111111111صص1صصصصصصصصصصصث111111ث1س122221111111111111
Here Lies Hiro The Japanese Engine You May Know That He Was The Strongest Engine At Home R.I.P
Well actually, that was a terrible message to write because Hiro is still alive.
how you made Hiros rods bronze
Tamiya power dash is the best motor to use on a normal battery. you should connect a battery to it before installing it to the train and let it run for a couple of hours it will increase in power and speed.
Thanks :P yes I think its a great mod and power dash is the one!
240 and 325 does that mean hero and hank are faster than BOLT
I got it in Australia at the Target toy sale it was $20 normally $39
Ucwpn can you make a map of how all the tracks on your table are set up?
2:58 reply to me what is that
Hank and Hiro are fast!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Turn the tender engine on in Hank
Where is the sound effect station ?
I know I am VERY VERY late commenting on this video. I know I know. But I wanna know where that hotwheels rpm tester came from
Hank jumped the points
Can you please make a video on how to swap a motor?
Nick Mohr ua-cam.com/video/5GAh7m12z_8/v-deo.html
+Ucwepn can you put a coupling of the trackmaster hank
maybe if you put another motor in side hanks tender he could go up hill and maybe go faster
TARDIS on the Red Bridge
HAH!! THE SLOW MOTION CLIP!! PRICELESS!! Good video nonetheless!! :D
pls make a other race run pls but there pulling something
Hiro Is Still Alive!
dude that motors are easily buyable at a hobby shop
Hiro is faster than Hank
06:17 There's the TARDIS on top of the bridge!
How do you know it's the TARDIS?
Put it on the 2009 trackmaster thomas.
I think it's the cow cahcter
Hank you have let me down I'm American and so are you
I'm Only Joking!
i have tamiya and yes i have those motors
But He Has Died
Well actually, Hiro never died really! It is just a joke!
LOOOOOOOOOOL NOOOOOOOO
p.s. didn't sound good at all...
I Like Your Hiro.Can I Have It?
,
I Wrote
Nothing!
FIRST