VTT is half the main voltage. For instance if the RAM is DDR3 the main voltage is 1.5 so VTT would be 0.75 which is half the main voltage. This applies to all RAM type. I hope this help.
First you need to know what and which power rail is shorted to ground, then you connect black wire from the dcbench to the screw holes 🕳 on the board, then the red cord on the shorted power rail, but you need to set your voltage, if 19v is shorted, you set your dcbench to 19v
Your way of explanation was good brother keep it up... 👍
I appreciate 🙏🏾
Thank you for the videos and the pdf book.
Hi , you spoke about RAM voltage (VTT) and said on VTT must be always voltage present on it !! but how many voltage usually must be on VTT ?? tnx
VTT is half the main voltage. For instance if the RAM is DDR3 the main voltage is 1.5 so VTT would be 0.75 which is half the main voltage. This applies to all RAM type. I hope this help.
I'm learning much
Don’t forget to share the content
Hi there , at 03:02 on schematic what is meaning of (B++) ?? and what is different between B+ AND B++??? Thnx
The ic u replaced, is it having the same number as the faulty one?
hi how you check if that mosfet is shorted ?you just put one pin with ground and one with the mosfet ?
ua-cam.com/video/-0WjwVDtBR0/v-deo.html
can i request how do you connect the connection from the dcbench to the motherboard to check for short. thanks
First you need to know what and which power rail is shorted to ground, then you connect black wire from the dcbench to the screw holes 🕳 on the board, then the red cord on the shorted power rail, but you need to set your voltage, if 19v is shorted, you set your dcbench to 19v
gj bro !
Remove music