Code states the use of yellow primer, pva adhesive and wrap the joint with self adhesive drywall mesh tape in our region, also the pipe must be capped off with a black latex glove.
Honest question - why no hub fitting there vs hubbed? Won’t that be logical failure point for some overzealous roto rooter in the future (although I will say that with all the earth around it would likely keep it from getting torqued out of place?).
I always use a Tork wrench set to inch pounds. It's the only way you can guarantee they don't strip and will hold as intended. Almost any bolt on autos to airplanes has a preferred/ recommended Tork spec.
I would hire them, always does a great job.
One suggestion is to put in a drain basin and put the pipe under grade
Good job but you know You Tube Experts are on their way 😢
I enjoy your videos. It's funny to me that These "experts" get so emotional over the videos. Funny as hell. Go ahead Diaz! My man!
I realize when he does something right, nobody comments.
Looks way too high to me 😂😂😂 they are usually at ground level
That's dope
Code states the use of yellow primer, pva adhesive and wrap the joint with self adhesive drywall mesh tape in our region, also the pipe must be capped off with a black latex glove.
Mil usos el amigo 👍
I’ll be impressed when I see you change the transmission on a dodge 2500😂
Why not use a glued in union instead of the fernco?
In the event it has to be replaced again.
Honest question - why no hub fitting there vs hubbed? Won’t that be logical failure point for some overzealous roto rooter in the future (although I will say that with all the earth around it would likely keep it from getting torqued out of place?).
Trip hazard lol
Lol the only double band clamp in the world to actually get torqued to "spec". What is the spec
30 pounds possibly
@@jaredmatso765760 ft lbs. in my area inspectors dont check each clamp but they do check that you at least have a torque wrench on site.
it is all listed on fernco's website 60 inch lbs, which is 5 ft lbs
I always use a Tork wrench set to inch pounds. It's the only way you can guarantee they don't strip and will hold as intended. Almost any bolt on autos to airplanes has a preferred/ recommended Tork spec.
❤
Serious question not bird dogging, why still use purple primer ?
I’m a newb, what else is there?
The rubber will in time rot
Esos para que son?
Sewage clean out.