Digilent Nexys: Microblaze and GPIO Design Implementation

Поділитися
Вставка
  • Опубліковано 24 гру 2024

КОМЕНТАРІ • 14

  • @EngineerAnandu
    @EngineerAnandu 7 місяців тому +2

    very good.please upload more vids.

  • @hoa.yev.219
    @hoa.yev.219 Місяць тому +1

    Hello! Do you know the error Microblaze is held in reset? I'm stucking in that error.

  • @優さん-n7m
    @優さん-n7m 2 роки тому +4

    SDK replaced with Vitis right?

  • @satyajyothikaperni2589
    @satyajyothikaperni2589 Рік тому +1

    Sir can I connect an external sensor to xadc by using micro blaze

  • @arslanmajid1381
    @arslanmajid1381 Рік тому +1

    No need of constraints file ?

    • @nielfotech4684
      @nielfotech4684  Рік тому +1

      Could you once check video at 03:24 & 05:28? When you add led, switch, clock signals etc. by this way, the constraints are already set automatically. You do not need to write those again.
      If you want to connect the signals manually, then you will need to write constraints.

    • @arslanmajid1381
      @arslanmajid1381 Рік тому

      @@nielfotech4684 OK thanks so I missed that part

  • @michaelalex5235
    @michaelalex5235 3 роки тому +3

    Nice job, thank you!

    • @nielfotech4684
      @nielfotech4684  2 роки тому

      Glad you liked it! Stay tunned more FPGA design.

  • @rupak378
    @rupak378 2 роки тому +1

    yoo the generate bitstream is taking more than 20mins

    • @nielfotech4684
      @nielfotech4684  2 роки тому +1

      @Ru
      Depending upon your device Processor, RAM configuration, the bitstream generation can take more time to generate. You better upgrade your PC, if you could.