is dual-mode is applicable to this? I am trying to tagged my eth 1/1/1 and dual-mode this but seems i can't do it due to the error of deprecated vlan, telling that i should config it into untagged vlan, ICX7150 C12P version 8.0.90t which is i don't understand why its happening.
Reply if obviously too late as I was not monitoring this channel, but for others who may run into the same issue: dual-mode is no more. It has been replaced with the more logical untagged keyword. This emulates "native" vlan in Cisco parlance. To set VLAN 10 as native (no dot1q tag) and also support trunking VLANs 10 20 and 30 vlan 10 untagged eth 1/1/1 vlan 20 30 40 tagged eth 1/1/1
how to display ip address in interface ruckus switch . when i write command show ip interface eth 1/1/1 . there is no information of ip address . can you give me a clue how to know /display ip address in interface ruckus switch , which command should i choose ? .
Great feedback. Should be resolved by changing volume on your side from 1 to 2. You can repeat this step of increasing volume till you arrive at a volume is just right for your environment.
command "router-interface ve 99" no see in Sw ICX7250-24 ???
Check and see if you are running router or switch code.
@@brentfloyd6033I understood and upgraded to a router. Thanks a lot
is dual-mode is applicable to this? I am trying to tagged my eth 1/1/1 and dual-mode this but seems i can't do it due to the error of deprecated vlan, telling that i should config it into untagged vlan, ICX7150 C12P version 8.0.90t
which is i don't understand why its happening.
Reply if obviously too late as I was not monitoring this channel, but for others who may run into the same issue: dual-mode is no more. It has been replaced with the more logical untagged keyword. This emulates "native" vlan in Cisco parlance.
To set VLAN 10 as native (no dot1q tag) and also support trunking VLANs 10 20 and 30
vlan 10
untagged eth 1/1/1
vlan 20 30 40
tagged eth 1/1/1
how to display ip address in interface ruckus switch .
when i write command show ip interface eth 1/1/1 . there is no information of ip address . can you give me a clue how to know /display ip address in interface ruckus switch , which command should i choose ? .
If ip address is set you can see this ip. Enter command - "show running config" and scroll page down.
@@ildarsadykov9723 sh ip interface ...or sh ip address
too soft ur voice
Great feedback. Should be resolved by changing volume on your side from 1 to 2. You can repeat this step of increasing volume till you arrive at a volume is just right for your environment.