Renault electronic parking brake cable repair

Поділитися
Вставка
  • Опубліковано 28 гру 2024

КОМЕНТАРІ • 21

  • @Daniel-dn7gv
    @Daniel-dn7gv 3 роки тому +3

    CALIBRATION ADVICE: As the idea is not apparent from the video I would like to share a piece of information how to calibrate this EPB. Sometime you wish the cable at the calipers is little longer or little shorter. The following advice is to calibrate the OPEN position. Personally believe this can be done also electronically with some diagnostic device, but if you don't have it read below.
    Should you need to calibrate the OPEN EPB caliper position you need to adjust the length of the cable from EPB. The short normal Scenic II has the EPB mounted on the right above the rear wheel. There is only one cable going out, the left side of EPB is closed internally. You do not need to dismount EPB from the vehicle and/or open it. For Grand Scenic, I think you can do the same, however you will need to open both sides. As the EPB in Grand Scenic is mounted in the middle of the axle this might become too difficult. Following steps are tested on normal short Scenic II:
    1. Pull the emergency break opening lever in the boot.
    2. Unscrew the plastic nut on the right side of the EPB
    3. Pull out the cable from the EPB. This is possible as of step 2. A little metallic square appears.
    4. Calibrate. Now you must turn the cable clockwise (for making the cable longer at the calipers) or anticlockwise (to make it shorter). This might bring some difficulty as the cable really must turn in the bowden from EPB down to the place where the cable forks to two calipers - in the middle of the axle. One turn is about 2 millimeters.
    5. Remember the emergency parking brake is now activated. You must connect the pieces together inside EPB however you don't see these. Anyway it is relatively easy. You need to place the metallic square back inside EPB. Now make the cable you see as long as you can by pulling it. Once ready swiftly push the cable in. Two or three tries and the mechanism inside locks.
    6. Put the plastic nut back and you are done.
    I wish there are two hidden buttons on the EPB to do this elegantly however there are none. Recommend to see also:
    ua-cam.com/video/ofjtk531yjM/v-deo.html

  • @renaudnicolas2530
    @renaudnicolas2530 2 роки тому

    Bonjour (french)
    Ou achetez vous les câbles pour les changer ?
    Merci

  • @kylebroadhurst9606
    @kylebroadhurst9606 4 роки тому +1

    How do you reattach the cables to the calipers once its reset

  • @istvannagy5428
    @istvannagy5428 Рік тому

    Sziasztok érdeklödnék hogy mi lehet az oka hogy nem húz be a kézifék?

    • @bowdenhu2467
      @bowdenhu2467  Рік тому

      Sok mindentől lehetséges. Ha kiszereled az egységet a bowdenekkel együtt, akkor ránézünk, hogy mi a baj (vagy személyesen elhozod vagy elpostázod címünkre).
      De telefonon is egyeztethetünk.
      Elérhetőség: bowden.unas.hu

  • @zeleznakpetr
    @zeleznakpetr 4 роки тому

    On ebay, I can see cables, that are only for hatch (lift)back. Is it the same for grandtour (combi) version, or is it different length?

  • @mohalex4214
    @mohalex4214 3 роки тому

    Problème frein ma électronique pour démarrege march pas ?

  • @sassike27
    @sassike27 6 років тому

    What lubricant do you use?

  • @brebangabor2185
    @brebangabor2185 6 років тому

    Jo estet kivanok
    Egy kerdesem lene legyen szives
    A renault kèzifek kötèl az pàszol a c maxra is ?
    Ès az elktromos rèsz az ujszintèn pàszol a renault rol a c maxra ?
    Nagyon szepen köszönöm elöre is

    • @bowdenhu2467
      @bowdenhu2467  6 років тому

      A renaultnak több mint 5 modelljén van elektromos kézifék ezeken a bowdenhosszok mind mások.
      A ford cmax-on is más bowden van , az elektromos egységek hasonlóak de a programozásuk más így az sem jó hozzá.A fordhoz is gyártunk kötelet azt tudok adni önnek.Meg kell nézni, hogy önnél mi a hiba.Csak bowdent kell cserélni vagy elektromos hiba is van.

  • @biti85biti95
    @biti85biti95 2 роки тому

    Bonjour comment supprimer le message frien main a contrôler sur laguna 3 svp

  • @karimtbina3421
    @karimtbina3421 2 роки тому

    Bonjour je cherche cable de frein à main électrique renault latitude si disponible et merci

  • @bogdanstancu6252
    @bogdanstancu6252 7 років тому

    Can anyone tell me which engine is that Johnson or other compatible engine?

  • @amana1480
    @amana1480 7 років тому

    How did you know the cables needed replacing?

    • @MrStevestomp
      @MrStevestomp 7 років тому +4

      Cables are normally replaced because they seize up you can strip your old ones and pour motor oil down inside to grease it and free it up. Another reason is that the ends of the cable where the ball connects to calliper get crushed where they grab on to the to calliper shortening the length and then they are useless!

  • @colinsaunders5358
    @colinsaunders5358 7 років тому +1

    Does the EPB module need reprogramming back to the car (because it has been removed) once the cables are changed for it to function again? Thanks for the video btw :)

    • @MrStevestomp
      @MrStevestomp 7 років тому

      Hit and miss I think sometimes it does sometimes it doesn't

  • @michaelpoulsen1998
    @michaelpoulsen1998 6 років тому

    Hi good video. Is there someplace we can buy new cables ?

    • @bowdenhu2467
      @bowdenhu2467  6 років тому

      Please click "show more" up and you can buy the cables on ebay. If it is not good for you, you can buy it my webshop: www. bowden.unas.hu

  • @asterioskyriakidis3698
    @asterioskyriakidis3698 Рік тому

    Hello ,mine parking brake engages normally manually and automatic but when i do it manually an "parking brake fault"pops up what can i do? As i said the parking brake works fine manually and automatic despite the fact the erroe pops up.please help me 😅

  • @michaelpoulsen1998
    @michaelpoulsen1998 6 років тому

    Ok Thanks eBay is ok with me I by Them there👍