Bond Girl Upper Loop Fix Install Instructions

This simple mod will help with the issue on your Bond pinball machine when the bond girl loop shot switch (from the upper flipper) frequently does not register. The cause of this issue is that ball will often “hop” over the switch due to it’s speed, even with the flipper power lowered from 220 (default) to 180.
This mod keep the ball from rising up above the switch by creating a ceiling for the lane. It has been tested extensively and addresses the ball hop issue 100% of the time at 220 power and below.
Installation takes no more than 5 minutes, does not require you to lift the playfield, and uses the existing hardware on your pinball machine. It’s made from 1/8” clear cast acrylic and laser cut.
Get it at www.teppinball...

[@grossag]

Great mod! Installed it today and it works great. First time I installed it I installed it too close so it trapped the ball. After adjusting now it’s great.

[@ToddHowardsChessClub]

Looks so simple, yet it just works! Thanks for a great mod 👍

[@teppinball]

Got it. Thx!

[@kach069]

This is so annoying because it is a challenging shot and if it doesn’t register….ugh. Ordered.

[@kach069]

Installed and it works perfectly and should have been included with the machine. Stern goofed.