How to setup your wing

Begin by removing your wing from its’ carry bag.
Turn so that your back is facing the wind and unroll the wing. Rotate it so that the leading edge of the wing is facing into the wind. Connect your pump leash and remove the valve cap before connecting your pump hose. Take note of the maximum psi of your wing. Set your pump on high capacity mode and begin to inflate your wing.
When you are nearing full inflation, switch the pump mode to high pressure to get your desired maximum PSI. Disconnect the pump hose, replace the valve cape and close the velcro over the valve.
Using the clip on the pipe between the leading edge and the strut, isolate the air pressures in case of an emergency.
Before disconnecting your pump leash, connect your wrist leash by threading the looped end through the handle and pushing the cuff through the looped end and pulling tight.
Release the velcro on the cuff, and slide your hand through and replace the velcro, pulling tight. Disconnect the pump leash.
And your wing is now ready to hit the water.
Produced by Samuel Tomé
Rider David Jeschke
Discover the GUNSAILS HY-Series: gunsails.com/e...
#wingfoiling #gunsails #hyseries