How do you know the senor was bad? You just found 12v, 5v, & gnd. You didn't back probe the signal wires on the harness to see if you got voltages in range for that specific car.
But that checks the voltage available at the wire end or socket. If it is ok it means correct voltage is being supplied to the MAF but how do you check if the MAF sensor itself is bad???
How do you know the senor was bad? You just found 12v, 5v, & gnd. You didn't back probe the signal wires on the harness to see if you got voltages in range for that specific car.
Ok boss
Great video! Please what electrical issue could cause a Toyota Avalon to have 3 ground instead of 2 as usual and no power?
Check all feus and wier conetion engine ECU ,,,,all wier conetion ok ,,, check engine ECU
Why the wire connector is the one to diagnose not the Sensor itself??
Thank you can you give me the part number of mitsubishi l200 (gazoline) MAF sensor
What is the problem if the maf sensor is installed the engine wont start but .whenthe maf sensor is unplugged the engine gets start.
Maaf sensor replace then check boss
Okay..il do it once the new maf sensor arrive.will update u soon.by the way thanks buddy for instant reply..
But that checks the voltage available at the wire end or socket. If it is ok it means correct voltage is being supplied to the MAF but how do you check if the MAF sensor itself is bad???
When wiring and supply voltage ok good, but maff sensor not working properly ok
@@SCSautomotive.1988 I just could not understand your answer
@@72shivaramk he would have cleaned it with CRC cleaner. And would have tested data of flow data and air temperature it s the procedure 🙏💐
Ok thanks for you
computerised voice? how do i know this wasn't plagurised off another site?
This car name please?
Toyota Estima
Am Try to start my car toyota 1zz 😢 but am struggling to start it am learn bit by bit 5:34 5:34
👌
👍👍👍👍👍
how about if -ve grounded got over 100 ohm
The multimeter should read between 200 and 600 ohms.
If I got no beeping sound on -ve wire what it's means ?
is it means wire to ground also have resistance?
Can you please leave the written information up long eniugh to bloody read
Ok
🤣🤣
Hi
Please I want to know how to repair airflowmeter sensor
Service or replace the air flow sensor,