Push the oil tube towards the motor, then bend the top back toward the intake manifold kinda like your gonna straight it out and the hole should be lined up
Oh yea?? I'll have to give that a whirl and see what happens! Good thing I still have the first tube for the o-ring because I ripped it on this one, hahah! Thanks for the tip!
I'm pretty sure evoscan has the documents! I found the documents there before but I also found them on Boosted Films channel on one of his videos. I would give you the link but I don't remember what video it was I saw the link!
I have always just used the Monoloc, and it’s widely been accepted as a collar of choice from what I know so just switched it out now to avoid potential problems later
Push the oil tube towards the motor, then bend the top back toward the intake manifold kinda like your gonna straight it out and the hole should be lined up
Oh yea?? I'll have to give that a whirl and see what happens! Good thing I still have the first tube for the o-ring because I ripped it on this one, hahah! Thanks for the tip!
Where did you get all the tourqe specs from 😅 could I buy I copy from you if it’s possible 😎😎
I'm pretty sure evoscan has the documents! I found the documents there before but I also found them on Boosted Films channel on one of his videos. I would give you the link but I don't remember what video it was I saw the link!
HEyy.. one question.. Why u use the ACT MOnolock and not the original one
I have always just used the Monoloc, and it’s widely been accepted as a collar of choice from what I know so just switched it out now to avoid potential problems later